Secondary Filter - Hoover TASKVAC H-8580 Quick Start Manual

2. Push on red lever over
a trash receptacle and
drop bag into trash.
(See Figure 13)
IMPORTANT! Do
not clean out old
disposable bag and
reuse. Discard used
bag.
3. Hold new filter bag
as shown. Slide the
cardboard sleeve into
the bag holder until bag
is securely in place.
(See Figure 14)
4. Fold bottom of bag and
tuck between ribs on
bottom door. Make sure
bag does not interfere
with door seal.
(See Figure 15)
5. Replace bag door by
placing tabs on bottom
of door into slots. Make
sure filter bag is securely
tucked into vacuum.
(See Figure 16)
6. Push door handle to
snap securely shut.
PAGE 6 OF 8
MAINTENANCE CONTINUED
Figure 13
Figure 14
Figure 15
Ribs
Figure 16
FILTERS: HOW TO CLEAN
CAUTION! To reduce risk of injury from moving
parts, unplug vacuum before servicing.
Do not operate vacuum without either the
secondary or final filter in place.

SECONDARY FILTER

1. The secondary filter
protects the motor from
dirt particles. If filter
becomes dirty, pull off
grill and lift out filter.
Hand wash filter in cold
water. Let filter air dry for
24 hours. Reposition dry
filter and grill.
(See Figure 17)
FINAL FILTER
1. The final filter assists in
the filtration process to
return clean air to the
room. (See Figure 18)
2. To remove the filter, pull
tab on filter holder down
and remove filter.
3. Lift out filter and hand
wash it in cold water.
4. Let filter air dry for 24 hours and reposition it on the
side of the filter holder and push filter holder back
into cleaner.
IMPORTANT! Allow filter to dry completely
before replacing. Dry filter on edge so air
circulates on both sides of filter. This may take
up to 24 hours.
BRUSHROLL: HOW TO CLEAN
CAUTION! To reduce the risk of injury from
moving parts, unplug before servicing.
1. Turn vacuum over so
bottom side is facing up.
Rotate red upper latch
counterclockwise.
(See Figure 19)
Figure 17
Figure 18
Figure 19
0120 IH-8580