Braemar SEER Event Recorder Instructions

SEER/Braemar Event Recorder
Instructions
6

Displays on the screen SEER Event Recorder:

* There will be two symbols that look like canisters
* The left one is your battery life and will be mostly all black. When it is empty (with no black
showing), batteries need to be changed
* The canisters on the right should be empty with no black inside at the time of hookup in the
hospital. There will be a little 6 at the top of the canister and 0 at the bottom. Which indicates
the recorder is empty (no symptoms yet recorded)
* The screen will also read at the top "NO ECG CABLE", once you plug in the lead set, it will
read "MONITORING"
Once the SEER Event Recorder is plugged in and attached to you:
* A square wave will display followed by rhythm signals which will then change to the
original screen (two canisters with "MONITORING" at the top flashing)
* SEER Recorder is ready for downloads now

How should I wear the SEER Event Recorder:

* You should have the record button accessible to you, so be sure to wear it in the most
convenient way
* You can clip the recorder on to a belt or slip into a pocket shirt or pocket

Things you can not do with the SEER Event Recorder:

* Recorder can not get wet or be exposed to moisture
* Must remove recorder before bath/shower or swimming

Replacing Electrodes from the end of the lead set:

* Change electrodes every 24-48hrs and every time you bath/shower or swim
* When replacing electrodes make sure skin is washed and dry
* Replace any loose electrodes immediately
* Do not reuse electrodes once removed or electrodes with dry gel
Display screen
Record/Send button
Speaker
Patient Cable/Connector
Battery Compartment
Cover