Subscribe to Our Youtube Channel
Summary of Contents for Multitek DIP-01
- Page 1 DIP-01 INDOOR / OUTDOOR PANEL INSTALLATION AND USER MANUAL E-mail: info@multitek.com.tr Web: www.multitek.com.tr...
-
Page 2: Safety Warnings
SAFETY WARNINGS For your own and the device safety, you should obey the security warnings; 1. Read the user manual carefully. 2. Read the safety warnings carefully. 3. Remarks about Transport, Shipment and Preservation - During transport and shipment keep the product with its case. The case will protect the product against the physical damages. - Page 3 GENERAL: a) When a visitor touches the blue color button on the device the monitor starts ringing and the screen shows the visitor. During ringing, if icon is touched the conversation starts. If icon is touched the door is opened. Touching icon stops the call any time.
- Page 4 Figure 4. Back side of the device DIP-01 door panel’s RJ45 socket located on the back side of the device is connected to a PoE switch with a LAN cable. No need for the connection of any power supply because the device takes the power through the ethernet cable.
- Page 5 3) MATCHING A DIP-01 TO AN IP MONITOR : Each DIP-01 device has to be allocated to a room, and this activity is done only once during installation period. To initiate programming, the device under power is removed from the wall mount apparatus where the programming swıtches appears.
- Page 6 Enter SETUP/General Settings/Send a message to the apartment door. Tap icon (Figure 3) “Message is sent” alert will be seen on the screen. This means that, message is sent to DIP-01 device which is on programming mode Figure 5. Monitor SETUP page Figure 6.
- Page 7 When INTERCOM icon on the menu page of the monitor is touched the calling screen with keypad appears. (Figure 7). INDOOR icon in this page is used to monitor the camera of DIP-01. icon on the new page establishes the voice communication.
- Page 8 Some VILLAs may have more than one door and it may be needed to talk/monitor and open the doors. NOTE 1 : If the VILLA has only one door, DIP-01 is connected to the door as INDOOR panel as explained in section 3.
- Page 9 6) USING DIP-01 AS THE VILLA DOOR PANELS: a) Calling the VILLA monitor by touching the DIP-01 button : DIP-01 has a touchmatic button with a blue color. When the button is touched the color of the button turns to yellow momentarily.
- Page 10 OTHER CALLS page brings the door cameras to the screen. Figure 9. SETUP / SPEED CALL page 7) UPGRADING FIRMWARE OF DIP-01 BY AN SD CARD The following steps are done: i) Take out the ethernet cable of the device.
-
Page 11: Technical Features
8) TECHNICAL FEATURES Camera : 0.3 Mpixel CMOS with night vision TFT Card : Yes CPU speed : 1.8GHz : 1GB FLASH : 4 GB : Android Transmission : TCP/IP Connection Protocol : SIP Voice codec : G.711 Video codec : H.264 Network connection : Ethernet (PoE) Working voltage...
Need help?
Do you have a question about the DIP-01 and is the answer not in the manual?
Questions and answers