Do you have a question about the RH816 and is the answer not in the manual?
Questions and answers
Summary of Contents for VRX Racing RH816
Page 2
Congratulations on your purchase of the VRX Racing 4WD electric cars. This 1/8th scale model has been factory assembled and all electrics installed and set up to make it the easiest possible. introduction to the sport of driving RC cars.
Aerial Assembly As the aerial wire on 2.4GHz system is so short you do not need to protrude through the body shell and it can be left to stand directly from the receiver. If you want the security of an aerial tube away simply cut it short, and insert in the usual way but do NOT bend over the last 5mm of aerial wire to retain it under the rubber cap, last two inches of aerialwire need to be straight with no kinks for maximum range and control with 2.4GHz system.
Getting Started Refer to 2.4ghz binding manual for radio set-up. Switch on transmitter Hold vehicle clear of the ground,connect battery pack and switch on receiver. Test the transmitter to check control of the vehicle with wheels off the ground. Start driving slowly and if the vehicle does not go straight ,adjust steering trim dial on Transmitter. For the very first run use the throttle gently,to help the driver become accustomed to the vehicles behaviour and controls.
LIPO BATTERY-USER SAFETY AND HANDLING INSTRUCTIONS. Read all safety instructions before charging or using your batteries for the first time. Lipo batteries require completely different charging and care than Nicd and NIMH batteries.Misuse can result in fire,personal injury and/or damage to property.The buyer assumes all Liability and risk associated with the use of Lithium-Polymer (Li-Po) batteries.Immediately retum the battery,unused,if you do not agree with these terms.
Page 8
Gear Box Assembly(Bag F) 差速箱组合 Differential Grease 差速油 RH5526 RH5117(4X4) 10003 RH5526 10233(10X5X4) 10133 10249(3X14) From Bag C 10233(10X5X4) 10120 10123 85127(3X18) 10124 Front Assembly A 前部套A Front Shock Tower(Bag F) 前防撞板 10101 85125(3X10) Front Assembly B 前部套B...
Page 9
Right Steering Set(Bag G) Screw Cement RH5102A 10241(3X10) 右转向组 螺丝胶水 85011L 10115 10233(10X5X4) 10228 10114 10228 10241(3X10) 10241(3X10) 10116 10114 10116 10233(10X5X4) 85011L 10115 RH5102A 10241(3X10) Left Steering Set(Bag G) 左转向组 Screw Cement 螺丝胶水 Assemble right steering set with front suspension arm. 右转向组和前下摆臂组合...
Page 10
Front Assembly D(Bag G) 前部套D 10120 10248(3X12) 10230 10251(3X36) Assemble front susp arm sets to front diff.set. 组装前摆臂组与前差速箱组 10249(3X14) Front Assembly E 前部套E Front Bag D 10249(3X14) 10249(3X14) Front Bag D 10141 Assemble front upper susp. arms. 组装前上拉杆组...
Page 11
Front Assembly F 前部套F 10245(3X18) 10245(3X18) 10001 85184(3X12) From Bag A 10001 Assemble front shocks 85184(3X12) 安装前避震器 Central Spur Gear Set(Bag H) RH5190(E4) 中间减速组 10228 10192 10193 10194 10195P 10193 10192 10196 10197 10191 RH5103 10232 10199 Screw Cement 螺丝胶水 RH5117(4X4)
Page 13
Rear Assembly B(Bag J) 10102 后部套B 10241 (3X10) 10315 Rear Shock Tower 后防撞板 Bag J RH5118(4X10) From Bag I 10713 10713 85144(3X4) 10230 10113 85144(3X4) 10230 10113 10713 10713 RH5118(4X10) From Bag I Assemble rear hub carrier set with rear lower susp arm.
Page 14
Rear Assembly D(Bag J) 后部套D 10102 10230 10230 10121 10251(3X36) 10248(3X12) Assemble rear susp arm sets to rear diff.set. 组装后摆臂组与后差速箱组 Rear Assembly E(Bag J) 10119 后部套E 10119 From Bag D 10142 10249(3X14) From Bag D 10142 Assemble rear upper susp.arms. 10249(3X14) 组装后上拉杆组...
Page 15
Rear Assembly F 后部套F 10245(3X18) 10245(3X18) From Bag A 10002 85184(3X12) Assemble rear shocks 安装后避震器 Wing Assembly(Bag K) 85037 尾翼组 10256(3X6) 10242 10712 10712 10575 10313 10242...
Page 16
Rear Assembly G 后部套G From Bag K 10242(3X14) 10241(3X10) Assemble wing set to rear assembly set. 组合尾翼组与后部套 Chassis A(Bag L) 地板组A 10381 10330 10378 10247(3X8)
Need help?
Do you have a question about the RH816 and is the answer not in the manual?
Questions and answers