Summary of Contents for Fukuyama OFS SLIMBOX-H, OUTDOORSVI-04FIBER-INSIDEADP
- Page 1 Installation Instructions for Slimbox 4 Fiber Indoor/Outdoor Enclosure 8/9/2017 This document describes the Assembly Instructions for the SlimBox-V, Indoor/Outdoor Enclosure – 4 fiber.
-
Page 2: Specifications
C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 1. Products The equipment is used as a termination point for the feeder cable to connect with the drop cable in a FTTx network. The fiber splicing, splitting, distribution can be done in the enclsoure and provides a solid protection and management for the FTTx network. - Page 3 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F Configuration Table Parameter Dimension (HxWxD) 186 X 116 X 40 mm Color Light Gray Material Plastic (PC + ABS) Adapter Type SC or LC Duplex that fits SC footprint No of Adapters 4 (LC Duplex that fits SC footprint) Splitter Type Nx 2, Nx4 and Nx8 No.
- Page 4 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 3. Product Structure and Cable Entry Adapter Ports Splice Flip Tray Cable Entry Drop Entry Accessory Package pg. 3 ISSUE DATE 8/9/2017...
- Page 5 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 4. Enclosure Installation and drop cable attachment 1. Start by opening the accessories package and find the mounting screws included in the product packaging. Attach the screws at the top and the base of the enclosure. 2.
- Page 6 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 3. Remove the grommet by sliding forward and notch through the web in order for the cable to enter. Run the cable through the notch and place the grommet back in the enclosures. The cable grommet is notched in the center and the drop cable is cut from the bottom.
- Page 7 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 5. When field terminating connectors utilize the vendor specific instructions for direct termination, mechanical or splice on connectors for 900 um buffered fiber. 6. When doing a mid-span cable the cable enters on the left side is wrapped two times and exits on the far right hand side drop port (only three drops are allowed in the mid-span entry).
- Page 8 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 8. Remove the top of the drop clamp and pull out the black grommet. Cut the base of the grommet to allow the drops to slide into the grommet before inserting it back into the enclosure. Then route the drop cables through the grommet ports and attach the connectorized end (SCU, SCA, LCU or LCA ) into the adapters.
- Page 9 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F Rear of Splice Tray Cable entry point Rear of Splice Tray Pigtail entry point 10. The Outside Plant cable is routed into the bottom left hand corner of the base and attached inside the bracket at the base of the enclosure. The cable is prepped with 38 inches of exposed unit tube that is routed in the base of the enclosure and routed to the rear of the flip tray.
- Page 10 C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F Splice Flip Tray Indoor/Outdoor Cable entry or tubed fiber from an OSP cable Splitter Attachment Splice Flip Tray Pigtail entry point. Pigtail is routed counter clockwise 5. Splitter Installation 1. Attach the splitter on the top of the splice flip tray. 2.
-
Page 11: Ordering Information
C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F 4. The input fiber from the splitter will be spliced in the splice flip tray to the specified fiber in the incoming feeder cable. 5. Store the splice protectors and slack in the splice flip tray. 6. -
Page 12: Technical Assistance
C17AK0006 REV.1SLIMBOX-V, INDOOR/OUTDOOR ENCLOSURE-4F Technical assistance OFS ensures that the technical information, statements, drawings and illustrations contained in this manual are reliable. However, the information may not be sufficient to install in certain conditions OFS reserves the right to make improvements, enhancements or changes to the products without prior notification including technical data and other information related to this product.
Need help?
Do you have a question about the OFS SLIMBOX-H, OUTDOORSVI-04FIBER-INSIDEADP and is the answer not in the manual?
Questions and answers