Page 2
INTRODUCTION Congratulations! You are now the proud owner of the Red Roo Model CMS100 Dear Valued Customer Chipper Mulcher Shredder. Please take a moment of your time to look over the following information. Familiarise yourself with this green waste recycling machine, Congratulations! You are now the proud owner of the Red Roo Model Hydraulic Trencher.
Page 3
WEB INFORMATION WEB INFORMATION WARRANTY POLICY WARRANTY POLICY RED ROO SALES & SERVICE COMPANY PTY. LTD. RED ROO SALES & SERVICE COMPANY PTY. LTD. 41-43 Keysborough Avenue, Keysborough, Victoria, Australia 3173 41-43 Keysborough Avenue, Keysborough, Victoria, Australia 3173 Tel.: +61 (03) 9769 0455 Tel.: +61 (03) 9769 0455...
The information contained in this manual has been prepared to assist you in the safe operation, the routine maintenance and general care of your Red Roo product. By following these guidelines, you may look forward to years of reliable service from your Red Roo. Information is categorised and denoted by the following symbols and phrases: Identifies general safety practices.
Page 5
USE COMMON SENSE AND PLENTY OF IT OPERATOR MUST BE TRAINED DO NOT allow other persons near the Chipper/Mulcher/Shredder. It is up to the operator to keep bystanders and animals a minimum of 6 metres (18 feet) away from the machine while in operation.
Page 24
Chipper Chute/Hopper Mulcher/Shredder Hopper Fuel Tank Engine Engine Exhaust Discharge Zone: OperatOr Material discharges ZOne directly onto the ground - Never Belt stand directly Guard behind the machine while in operation Clutch Safety T ow Throttle Control Chain Tow Coupling Jockey Locking Pin Wheel...
Page 26
Service Company, P/L, herein referred to as "MANUFACTURER", will, at its option, repair or replace for the original purchasers of new Red Roo equipment, free of charge, any part, or parts of the unit (excluding Power Unit, warranty coverage provided by respective engine manufacturer), found upon inspection and testing by a Factory Authorised Agent, or by the Factory at Keysborough, Victoria, to be defective in material or workmanship or both under normal operating conditions;...
Need help?
Do you have a question about the CMS100 and is the answer not in the manual?
Questions and answers