Summary of Contents for Sabrent DA-HDEX
- Page 1 1080p 3D HDMI Extender Over CAT6 (164 feet / 50 meters) HDMI CAT6 1080p @ 60Hz IR Pass-Through 1080p DA-HDEX USER MANUAL...
- Page 2 DA-HDEX USER MANUAL INTRODUCTION Thank you for choosing Sabrent. This HDMI Extender kit includes two main units: a transmitter (TX), and a receiver (RX). It allows an HDMI signal to be transmitted up to 164 feet (50 meters) at 1080p / 60Hz over a single CAT6 cable in a point-to-point configuration.
-
Page 3: Package Contents
DA-HDEX USER MANUAL Package Contents CAT6 CAT6 RESET LINK RESET LINK TRANSMITER UNIT X 1 RECEIVER UNIT X 1 DC5V/1A X 2 • 1 x CAT6 RJ-45 Compliance Test cable (1 meter) USER MANUAL X 1 IR BLASTER EXTENSION X 1... -
Page 4: Important Safety Instructions
DA-HDEX USER MANUAL Important Safety Instructions 1. Please note the different items to this product before proceeding. 2. When the device is plugged in, do not remove or attach any cables. 3. Only the included power adapter (5V DC) is approved for use with this device. It is not recommended to use any other power adapter. - Page 5 DA-HDEX USER MANUAL Transmitter unit (TX) CAT6 RESET LINK 1 - Reset button Press for restarting the unit 2 - RJ45 signal output Output enconded HDMI signal 3 - Link indicator LED indicator turns on when there is signal input, it flashes when there...
-
Page 6: Receiver (Rx)
DA-HDEX USER MANUAL Receiver (RX) CAT6 RESET LINK 1 - Reset button Press for restarting the unit 2 - RJ45 signal input Input enconded HDMI signal 3 - Link indicator LED indicator turns on when there is signal transmission, it flashes when... -
Page 7: Connection Diagram
DA-HDEX USER MANUAL CONNECTION DIAGRAM SOURCE HDMI EXTENDER / TX HDMI EXTENDER / RX HDMI DISPLAY 1080p @ 60Hz HDMI IN CAT6/6A/7 cable HDMI OUT HOW TO CONNECT IT 1. Connect your source device (Blu-ray, camera, etc.) to the Transmitter (TX), and your display device (monitor, TV, projector, etc.) to the Receiver (RX) via HDMI cables (not included). - Page 8 DA-HDEX USER MANUAL USING THE IR (INFRA-RED) REMOTE CONTROL PASS-THROUGH FEATURE This feature will allow you to continue using your infra-red remote control in spite of the distance between your source device and your display unit. 1. According to the diagram above, connect the IR IN signal cable to the receiver (RX). Then connect the IR OUT signal cable to the transmitter (TX).
-
Page 9: Troubleshooting
DA-HDEX USER MANUAL TROUBLESHOOTING If there is no output on the screen and all connections are correct, try the following: 1. Test your equipment with the certified CAT6 1-meter cable supplied with our unit. If it works with our 1-meter cable, the problem is the quality of the longer cable. - Page 10 Please contact our Technical Support Team for additional troubleshooting www.sabrent.com...
Need help?
Do you have a question about the DA-HDEX and is the answer not in the manual?
Questions and answers