ADJUSTING THE PILOT FLAME HEIGHT
A pilot that frequently blows out may be set too high, or too low. To adjust the pilot flame to the
correct height, perform the following steps:
1.
Turn off the controls and prop open the cooktop.
2.
Using a screwdriver, turn the needle valve screw slowly in the direction necessary to set the
size of the pilot flame, as shown in Figure 3-27. The flame should have a sharp, blue cone that
is approximately 1/4 " high, as shown in the inset.
3.
Lower the cooktop.
Adjustment
Screw
Pilot
Gas Line
Figure 3-27
Page 3-19
Inset
Bracket
1/4 "
Flame
Proper Flame Size