Interior Light -Bulb -Change - Electrolux AES II CARAVAN Manual

WARNING! THIS APPLIANCE MUST BE EARTHED.
In the United Kingdom, the plug or circuit to the refrigerator
must be fitted with a fuse not greater than 5 amps. If a 13
amp.(B.S.1363) fused plug is used, it should be fitted with a
3 amp. fuse. In other countries, the fuse rating will depend
upon the voltage and local practice.
230 V Supplies.
Check that the voltage stated on the data plate is the same
as the mains voltage in use (230 V).
Electrical leads must be routed and secured so that
they cannot come into contact with hot or sharp parts
of the refrigerator.
+
12 V and "D " Connection
The 12 V connection of the refrigerator is shown in fig. 10.
The (+12V) and (-) pole have to be connected directly to the
auxiliary (house) battery. Do not use the chassis for the
return lead. The battery cable must not be connected to a
voltage controller or similar device as the AES itself moni-
tors the battery voltage. A relay cutting out 12 V operation
when the ignition key is turned off, is not recommended.
All splices should be screwed or soldered to keep voltage
drop to a minimum. The positive conductor must be protec-
ted by a 16 A fuse.
+
The connection D (alternator) has to be connected to
the corresponding outlet of the vehicles electrical
system.
Cross- sections
+
The D (alternator) connection does not carry high current,
therefore it is no need to use a high cross- section cable.
For the 12 V (+) and (-) leads, we recommend a 6 mm
wire. Up to a length a 5 m, 4 mm
well.
Please consult a specialist, if you are not familiar with
the 12 V electrical system in your motorhome.
INTERIOR LIGHT- BULB- CHANCE
If a bulb has to be replaced, proceed as follows:
1. Remove cover of the lamp.
2. Put a small screw driver between the case of the lamp
and the lamp cover and remove lamp cover.
3. Turn bulb socle for 90 degrees and remove it.
4. Put in new buld and turn it again for 90 degrees.
5. Install lamp cover on the lamp case.
12
2
2
might be sufficient as