Table of Contents
Advertisement
Quick Links
Made by TOM.bv
ASSEMBLY INSTRUCTIONS
This assembly manual concerns indications for a correct execution and for the maintenance of this new cycle
(read this manual before you assemble and use this article). Adult assembly is required. Keep this manual for
future reference. If you have problems or questions please contact our customer service at customerservice@
tom-bv.com. When you remove/pull the black protection pads on the front and rear axles, look first if you do
not take away a screw inside this pad before throwing away.
- Have a good time with this bicycle!
Adult supervision is required. Draw attention to your child concerning possible danger. The cycle contents to the
established European norm DIN EN 14764 (minimum Saddle height 635 mm) or DIN EN 14765 (minimum saddle
height 435 mm to maximum height 635 mm) + DIN EN 14782 A responsibility of the manufacturer is out of the
question by imprudent use of the cycle by your child.
It is required by use of this cycle to wear practical clothes and closed shoes. AMIGO Bicycles advise to wear a helmet.
The helmets be found in our assortment (www.internet-bikes.com). This cycle can not be used for sporting use (by
example jumping etc.).
Take the cycle out of the packing and collect all of the parts. Check if all the parts are available.
ASSEMBLY ONLY ALLOWED BY AN ADULT.
Advertisement
Table of Contents
Summary of Contents for TOM.bv AMIGO Norm NM
- Page 1 Made by TOM.bv ASSEMBLY INSTRUCTIONS This assembly manual concerns indications for a correct execution and for the maintenance of this new cycle (read this manual before you assemble and use this article). Adult assembly is required. Keep this manual for future reference.
- Page 2 1. Assembly of the saddle Place the saddle with the pen in the saddle tube. Watch the safety marks on the pen. Put the saddle on the correct height for your child. You can adjust the saddle that at least the toe will reach the ground, for preference the whole foot touches the ground to guarantee a better stand.
- Page 3 If additional brake adjusting is required you can bring the brake rubbers closer to the wheel rim by turning the adjusting screw counter-clockwise. Be sure the cable is locked securely through the anchor bolt. Reset the cable adjuster lock nut when adjustment is final. WARNING: If you have problems with the adjustment, please do not use the cycle and have the brake repaired or adjusted at a bicycle service shop.
- Page 4 10. Adjusting the back-pedal brake for children’s bicycles For children’s bikes, it is advisable to check that the rear wheel does not turn stiffly before use. If this is the case, the cause is often due to the back-pedal brake that is set too tightly.
- Page 5 Recommendations Check your cycle regular on any damages, wastage or released parts. You have to hold the sides of the rims fat free. The chain must be oiled regular (chain or universal oil). Check the pressure of the tires regular. The pedals must be attached very well.
Need help?
Do you have a question about the AMIGO Norm NM and is the answer not in the manual?
Questions and answers