Olympia L-7470 Series Installation Manual

OLYMPIA FAUCETS, INC.
Interchange City Distribution Center #20
1277 Heil Quaker Boulevard
La Vergne, TN 37086
(888) 772-7701
www.olympiafaucets.com
Model Number: L-7470, L-7472 (CP, PVD BN,
ORB)
Warnings and Notes:
Check with local plumbing code requirements before installation.
This product should be installed by a local listed plumber.
Do not use plumbers putty on threads.

Installation Steps:

Two Handle Lavatory Widespread Faucet

(1) Shut off water supplies. Remove old faucet.
Clean mounting surface in preparation for new
faucet.
(2) Ensure there is a washer under the spout
flange. Place the spout in position on the sink.
From under the sink slide mounting bracket
through spout shank. Thread nut onto spout
shank properly and tighten nut
(3) Thread "Y" connector to the spout shank.
Ensure there is a washer in the "Y" connector.
Do not overtighten.
(4) Thread valve flange to valve. Install Cold
and hot handle to the valve with the help of
3/32" Allen wrench. Place hot and cold side
valve in position on the sink. Ensure handles
turns in correct direction.
(5) From under the sink place washers and
thread locknut with the help of 1-11/32" size
socket. Connect outlet hose to Y connector.
Connect inlet tube to water supply.
Tools:
Adjustable Wrench Plumbers Putty Sealant Tape

Pop-up Drain Installation:

INSTALLATION
(6) Turn on water supplies. Check for any
minor joint leaks. Remove aerator from spout
by turning counterclockwise. Turn on both side
handles. Flush and allow water to run at full
flow at least one minute. Turn off both side
handles. Replace aerator
(1) Remove pop-up flange from body
(2) Place a ring of putty on the bottom of
flange.
(3) Insert pop-up flange through drain hole
and attach flange to body. Ensure the pop-
up outlet faces towards the sink. Do not
overtighten.
Rags