Subscribe to Our Youtube Channel
Related Manuals for Kicker V55 PWRA207
Summary of Contents for Kicker V55 PWRA207
- Page 1 PWRA207 Designed for 2007-2010 Jeep® Wrangler two door with base audio T-TAP x2 FUSE WIRE TIES x6 SUBWOOFER ASSEMBLY 200 WATT AMP BRACKET ASSEMBLY POWER HARNESS OVERLAY HARNESS ©2012 Stillwater Designs Page 1 of 10 PWRA207-A2-20140731...
- Page 2 CONTENTS CON’T BRACKET ASSEMBLY 5-CHANNEL AMP POWER HARNESS M6 BOLT FUSE AMP SCREWS x4 AMP WASHERS OVERLAY HARNESS x4 WIRE TIES x6 Radio Removal 1. Disconnect the negative battery terminal. 2. Using a panel removal tool, pry up on the plastic trim panel located above the radio. Make sure to pry on the side of the panel closest to the window.
- Page 3 4. Remove the four screws securing the radio trim bezel. There are two at the top and two at the bottom. Fig. 3 5. Starting at the top and working your way down pull out on the trim bezel to release the fasteners securing it.
- Page 4 Fig. 7 Fig. 8 12. Place the amp on top of the bracket by sliding it under the dash past the brake pedal. Make sure the connecters on the amp are facing toward the fire wall and the mounting holes are facing down. 13.
- Page 5 19. Remove the two 10mm bolts temporarily installed in step 11. Position the previously removed metal plate over the top of the amp bracket and secure both with the two 10mm bolts. 20. Tighten the bottom bolt. 21. Loosen the four screws indicated by the arrows in Fig. 12 approximately 4 turns. Fig. 12 22.
- Page 6 Fig. 15 Fig. 14 31. Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it. 32. Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to prevent the connector from accidentally coming disconnected.
- Page 7 Fig. 18 Fig. 19 41. Set the subwoofer in place and connect the wire harness. 42. Align the mounting bracket with the anchor points at the bottom of the seat and press the enclosure down until it locks into place. Fig. 20 43.
- Page 8 Troubleshooting the Kicker Integrated Systems If you experience a problem once the Subwoofer is installed use this guide to locate the trouble. The radio is working, but the Subwoofer is not working: • Check the battery voltage to make sure it is not discharged below 11 volts.
- Page 9 Check ground wire with voltmeter to insure it is properly a good ground Low battery voltage Recharge the battery If you continue to experience problems after troubleshooting with this list, please contact KICKER Technical Support at (800) 256-0808 ext. 6009, or support@kicker.com. Page 9 of 10...
- Page 10 P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510 Page 10 of 10...
Need help?
Do you have a question about the V55 PWRA207 and is the answer not in the manual?
Questions and answers