Samsung Verizon Galaxy Note 4 Manual page 4

Assembly
Step 1: If present, remove the film from the back of the LCM by pulling
up on the blue and green tabs. This will expose the copper film on the
back of LCM along with the top and bottom adhesives.
Step 1A: If the adhesive is not pre-installed, the two following
procedures may be followed.
Use of pre-made adhesive: Separate from the protective film and apply
it to the plastic frame as shown.
Step 2: If premade is not available, use the approved roll adhesive.
Step 3: Apply to the areas in RED.
Ensure that the sensors on both sides of the Receiver Speaker Grill and
the Left / Right Softkey Flexes are not covered.
Step 4: Connect the LCM Flex Cables to the Main PCB.
Step 5: Align the LCM with the Receiver Speaker Grill and the Home Key.
Lightly adhere the LCM to the Plastic Frame.
Step 6:Starting with the lower portion install the assembly into the Back
Housing.
Once installed press firmly on the LCM in various areas to ensure it is
adhered well to the Plastic Frame.