Summary of Contents for Stillwater Designs KICKER VSS PWRA407
- Page 1 PWRA407 Designed for 2007-2010 Jeep® Wrangler four door with base audio BRACKET ASSEMBLY 5-CHANNEL AMP POWER HARNESS M6 BOLT FUSE AMP SCREWS x4 AMP WASHERS x4 OVERLAY HARNESS WIRE TIES x6 Page 1 of 9 ©2012 Stillwater Designs PWRA407-A2-20140731...
-
Page 2: Power Harness
SUBWOOFER ASSEMBLY 200 WATT AMP OVERLAY HARNESS T-TAP x2 POWER HARNESS FUSE WIRE T IES x6 Radio Removal 1. Disconnect the negative battery terminal before you begin. 2. Using a panel removal tool, pry up on the plastic trim panel located above the radio. Make sure to pry on the side of the panel closest to the window. - Page 3 6. Remove the screws securing the radio and pull the radio from the dash and disconnect the wiring. Disconnect the antenna cable by pulling the locking antenna connector away from the radio. Caution: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
- Page 4 12. Place the amp on top of the bracket by sliding it under the dash past the brake pedal. Make sure the connecters on the amp are facing toward the fire wall and the mounting holes are facing down. 13. Using a Torx® T-25 screwdriver install the four supplied screws and washers to attach the amp to the amp bracket.
- Page 5 Fig. 13 Power Harness Installation 24. Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it. Fig. 25. Using a razor knife make a small cut in the center of the grommet. Pass the end of the wires with the small terminal on the ends through the grommet and pull the grommet up to the point where the plastic sheathing starts.
- Page 6 31. Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it. 32. Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to prevent the connector from accidentally coming disconnected. 33.
- Page 7 Fig. 22 43. Reinstall all previously removed parts in reverse order. 44. Reinstall supplied fuses in the fuse holders under hood. 45. Reconnect the negative battery cable. Torque to 5Nm. Troubleshooting the Kicker Integrated Systems If you experience a problem once the Subwoofer is installed use this guide to locate the trouble. The radio is working, but the Subwoofer is not working: •...
- Page 8 Symptom Possible Cause Solution Fuse not installed in inline Install fuse(s) into fuse holder(s). Refer to fuse holder on subwoofer instructions for correct placement and/or amp harness Low battery voltage Recharge the battery Negative battery cable not Reconnect negative battery cable connected Power wire connector not Connect power wire to body harness.
- Page 9 If you continue to experience problems after troubleshooting with this list, please contact KICKER Technical Support at (800) 256-0808 ext. 6009, or support@kicker.com. P.O. Box 459 • Stillwater, Oklahoma 74076 • USA • (405) 624–8510 Page 9 of 9...
Need help?
Do you have a question about the KICKER VSS PWRA407 and is the answer not in the manual?
Questions and answers