SWISS+TECH Hand Mount Tool Light Quick Start Manual

Hand Mount Tool Light

For Right or
Left Hand
Use
Positive
Side (+) Up Side (-) Up
Two CR1025 Batteries

Battery Replacement

1. Loosen captive screw (remains in housing).
Open hinged Tool Light cover.
2. Remove old batteries.
3. Replace with two new CR1025 3V lithium
batteries or equivalent with positive (+) and
negative (–) sides positioned as indicated.
4. Close hinged cover. Tighten screw gently.
Velcro
Wrist
Strap
Right Hand
Use
1. Unsnap elastic strap, thread through Tool
Light arms as shown (bulb opposite snaps).
2. Reattach middle snap.
3. Insert thumb into elastic strap loop.
4. Wrap Velcro wrist strap around wrist.
5. Adjust for comfort.
AVOID OVERTIGHTENING OR SNAGGING TO
PREVENT BREAKING TOOL LIGHT ARMS.
Negative
This product contains button batteries.
IF SWALLOWED, batteries could cause
Captive
severe injury or death in just 2 hours.
Screw
SEEK MEDICAL ATTENTION IMMEDIATELY.
• Always purchase the correct size and
grade of battery most suitable for the
intended use.
• Clean the battery contacts and also those
of the device prior to battery installation.
• Ensure the batteries are installed
correctly with regard to polarity (+ and -).
• Remove used batteries promptly.
• Replace all batteries of a set at the
same time.
Elastic Strap Loop
Middle
Snap

BATTERY WARNINGS:

1-800-414-8799
www.swisstechtools.com
Elastic Strap Loop
Velcro
Wrist
Strap
Left Hand
Use
1. Unsnap elastic strap, thread through Tool
Light arms as shown (bulb opposite snaps).
2. Slide elastic strap to the buckle.
3. Reattach middle snap.
4. Insert thumb into elastic strap loop.
5. Wrap Velcro wrist strap around wrist.
6. Adjust for comfort.
AVOID OVERTIGHTENING OR SNAGGING TO
PREVENT BREAKING TOOL LIGHT ARMS.

Limited LIFETIME Warranty

This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free from
defects in workmanship and materials. During the
warranty period, this product will either be repaired or
replaced with a product of equal or greater value,
excluding any custom engraving or printing.
Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED
TO, IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR USE.
This warranty gives you specific legal rights, and you
may also have other rights which vary from state to
state. Simply return your SWISS + TECH
postpaid and insured to:
Swiss + Tech Products
30725 Solon Industrial Pkwy
Solon, OH 44139 USA
Patent pending. Made in China. MMMMMMMMI™
and MI™ are trademarks of Swiss + Tech Products.
Specifications are subject to change without notice.
©2012 Swiss + Tech Products, Solon, OH 44139 USA
ST74096
Middle
Snap
® brand product