Sensio SE9072HD Installation Instructions

Hd led linkable strip light - 600mm

Advertisement

InstructIons
IMPortant: please read these instructions before commencing installation and retain for future reference.

Components

2 x Fixing Brackets
1 x sE9072HD lED
linkable strip light

Important safety information

Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference.
We recommend that you consult a qualified electrician.
All electrical installations must be carried out in accordance
with current Iee wiring regulations (BS7671).
these products must not be modified, if any modifications are
made, it may invalidate the warranty and may render the product
unsafe. these lED lights operate low voltage (24V).
do not wire the individual Led light fittings directly to the mains.
This product is for indoor use only. Keep out of moisture and use
only in dry rooms.

Safety instructions

1. Before commencing installation or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. this product requires a 24V lED driver which is only
suitable for connecting to a 240V 50Hz supply.
3. the light should be mounted onto a secure surface.
Waste electrical & electronic equipment (Weee)
the symbol on the product, or on the document accompanying the product, the crossed out
wheelie bin symbol, indicated that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic waste.
HD LED
LINKABLE STRIP
LIGHT - 600mm
Code: Se9072Hd
1 x Fitting Instructions
1 x connector cable
Tools required
Pencil
10mm
Drill Bit
• If in doubt installation must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
• the Wattage of this product is 7.1W. Make sure that
the lED driver used with these fittings has an adequate
max wattage.
• We recommend using the sE40555 15W 24V lED Driver with this
fitting. You will be able to run a maximum of 2 fittings per driver.
alternatively, use the sE40556 30W 24V lED Driver. a maximum
of 4 fittings can be run from this driver.
4. Position lights where they will not be exposed to steam
or splashes etc.
5. suitable for furniture lighting.
6. When the lamp expires the fitting must be replaced.
7. class III safety extra low voltage (sElV).
PZ1 screw Bit
Power Drill

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SE9072HD and is the answer not in the manual?

Questions and answers

Summary of Contents for Sensio SE9072HD

  • Page 1 IMPortant: please read these instructions before commencing installation and retain for future reference. Components Tools required 2 x Fixing Brackets 1 x Fitting Instructions 1 x connector cable 1 x sE9072HD lED Pencil 10mm PZ1 screw Bit Power Drill linkable strip light...
  • Page 2 • Do not use harsh chemical solvents, it may dis-colour or damage the finish. Unit 7 Speedwell Road, Whitwood, Castleford, West Yorkshire, WF10 5PY www.sensio.co.uk technical drawings for illustration purposes only, sensio has the right to change any information without prior notice. Make sure you check all hole cut outs before work commences.

Table of Contents