Advertisement
Quick Links
ONLYON BOARD
Onlyone Board–O-3&O-4User Manual
Onlyone Board(www.onlyoneboard.com)
Onlyone Board
Onlyone
Thank you for purchasing Our
,
skateboard is
committed to providing great experience at much more affordable
prices.
Please read through all the information within this guidebook before you
Start to ride your board.
Warning
Your board may disconnect with the remote controller at some time due
to the radio interference. Please be aware that you might risk injuries
each time you ride an electric skateboard. Make sure to read the
following instructions before you start a ride.
1, Read User Guidebook Before Ride;
2, Make Sure to Wear Helmet and Other Protection Kits;
3, Please Abide By Local Traffic Rules and Regulations;
4, Do Not Ride on Wet Roads or Surfaces;
5, Always Check and Make Sure All the Screws Are Tightened;
6, Always Check the Remote Controller's Battery Level;
7, Avoid Riding Downhill whith high speed Unless you are an expert;
8, Do Not Always Rely on Brakes and always think ahead to brake the
Advertisement
Summary of Contents for OnlyOne O-3
- Page 1 ONLYON BOARD Onlyone Board–O-3&O-4User Manual Onlyone Board(www.onlyoneboard.com) Onlyone Board Onlyone Thank you for purchasing Our skateboard is committed to providing great experience at much more affordable prices. Please read through all the information within this guidebook before you Start to ride your board.
- Page 2 ONLYON BOARD Board when in high speed. 9，Do not downhill when fully charged. Get to Know the Board Get to Know the Remote...
- Page 3 ONLYON BOARD Note: In the following circumstances(Not limited to below), the remote will vibrate: 1, The board was adjusted from one speed mode to another; 2, The board battery runs low; 3, The board direction is switched; 4, The board disconnects with the remote; 5, The remote is turning off.
- Page 4 ONLYON BOARD 1, Press the power button on the side of the enclosure. A red light will be flashing. That means the board is on, but the remote is not yet on; 2, Long press the power button on the side of the remote for a few seconds.
- Page 5 ONLYON BOARD 3, If customer still finds it difficult to pair up the board with the remote, please do not hesitate to contact us at onlyoneboard@gmail.com. How to Identity Battery Level Board Battery Level 1, Make Sure Both Remote and Board are Turned On; 2, Press the power button on the remote and look at the board power indicator.
- Page 6 ONLYON BOARD its red light’s moving speed. Press the speed switch, if the red light on the board power indicator moves the slowest, it means the board is set on the slow mode. If it moves the fastest, it means the board is set on its fastest mode.
- Page 7 ONLYON BOARD bearings and the hub motors; 2, Always make sure the screws on the deck and hub motors are perfectly tightened; 3, Always check the board and remote’s battery level; 4,Avoid high speed downhill riding when the board is fully charged up; 5, Remember to charge the board regularly even if you don’t use it for a long time;...