Advertisement
ONLYON BOARD
Note:
In the following circumstances(Not limited to below), the remote will
vibrate:
1, The board was adjusted from one speed mode to another;
2, The board battery runs low;
3, The board direction is switched;
4, The board disconnects with the remote;
5, The remote is turning off.
Charge the board
1, Connect the battery charger with the wall charging socket;
2,Plug in the socket and start charging the board;
3, When the board is charging, the charging brick will show red lights.
When the board is fully charged up, the red light turns green;
4, It is normal to have the charging brick very hot during the charging
process. It will cool down when it is fully charged up;
5, Please keep an eye on the board while it is charging. Do not charge it
while nobody's home or everyone's sleeping.
Turn on the Board & the Remote
Advertisement
