Advertisement
Advertisement
Table of Contents
Summary of Contents for Janome Sit Down Table with Machine Front to Back
- Page 1 Sit Down Table with Machine Front to Back...
- Page 2 © 2015 Printed in the United States First Print Feb 2015 Second Print June 2015...
- Page 3 Step 1. Unpack the box your table and legs were shipped in. Long extrusion Short extrusion Step 2. With the main table in the box you can put the legs on. You will notice the main table legs have extrusions on them for attaching the leaf support legs.
- Page 4 Step 4. Once you have all four legs attached prop- erly with the provided bolts. Turn the table over. Figure 7 is showing the front of the table with the cut out for changing the bobbin. Figure 8 and 9 are showing the legs attached to the main table with the extrusions Figure 7 This is the front of the table the cut out...
- Page 5 Step 6. Pull the legs from the box and locate the bolts and nuts for attaching the legs to the main table legs. Step 7. Using 1 bolt and nut per leg attach them to the legs on the main table. Figure 11 shows two of the legs and four of the bolts Figure 12 shows positioning the leg...
- Page 6 Placing the machine on the ta- ble. With the table assembled you are ready to place the machine on the table. Step 11. Locate four small rubber pads that the Figure 19 Figure 20 machine will rest on. These look like half circles. Figure 19 Step 12.
- Page 7 Hanging the Extensions. This table comes with extensions for both the right and left side of the table. These are hinged exten- sions that rest on support legs which are mounted to the main table legs. These support legs will swing flat towards the extension fold down so that you do not have to take them off when not useing them.
Need help?
Do you have a question about the Sit Down Table with Machine Front to Back and is the answer not in the manual?
Questions and answers