Party Warehouse Peg & Pole 10m x 15m Setup Instructions

10m x 15m Peg & Pole Instructions
Thank you for choosing a Party Warehouse Marquee for your event.
S
ome Basic Rules:
Please do not drag or walk on any marquee sections
Please do not stick adhesive tape to the walls. This leaves a residue which is difficult
to remove. Use the poles if you wish.
Please do not light fires, including braziers, close to the marquee. Do your best to
ensure the marquee is up wind of any fire however small, as the smoke and ash will
stain the marquee. If using heaters ensure that direct heat is not applied to the
marquee roof or walls
TAKE CARE!! If you are unsure on anything, please do not hesitate to contact us, we
will be happy to guide you through any stage of the set up process.
Have a good time as that is what the marquee is there for. How ever just apply
common sense and ensure that party goers do the same. The material is a high
quality PVC and is highly durable; however excess weight or sharp objects will cause
it to tear.
1) Preparing the Roof – 3 sections:
Lay the marquee roof sections out flat on the ground and lace them together.
There is a rope that runs along the outer perimeter of the roof, this rope is on the
inside and should face down.
Lay the three sections out so the eyelets of one section line up with the laces of
the other. With the two Ends sections at the end and the Mid sections in the
middle. Starting in the centre of the sections and working out, begin to lace the
marquee together. Making sure you start with the first eyelet and the first lace,
put the first lace through the first eyelet then put the second lace through the
second eyelet then put the second lace through the first lace and pull it towards
you.
Continue this process until you get to the outside of the marquee and tie it off. If
the number of eyelets and laces do not match you have missed one and will
have to start again. Once you have laced the two sections together pull the
marquee out flat, this will be the area covered by the marquee once erected.
10m x 15m Peg & Pole Marquee Setup Instructions – Party Warehouse. Page 1 of 3