Table of Contents
Advertisement
PAGE 2
The installation of the system shall be done in accordance with the installation manual provided by Prins Autogassystemen.
This manual is based on Dutch regulations, always install the system in accordance to the local regulations.
For an optimal functioning of the Direct LiquiMax-2.0 system, maintain a clean and organized work environment during
installation and maintenance to prevent pollution of the LPG components.
Always download the "general manual 1/2 " from our website for basic instructions and diagrams.
Always disconnect the battery when installing / servicing the LPG system. Make sure the ignition key is outside the car.
Be aware of central door locking, radio / telephone memory code, alarm system.
Wear safety goggles when working on the petrol filled system / connections ( pressurized petrol )
Do not place the main fuse into the fuse holder before having completed the installation of the system.
The AFC has to be activated by means of the Prins diagnosis software.
Never disconnect the AFC connector, unless you have removed the main fuse.
When installing the wiring harness, ensure that it does not run near any of the ignition components.
Solder and insulate all electrical connections.
The wires in the loom are provided with numbers and text. The text on the wire explains the function of the wire.
The wire harness is not model specific, therefore is it may be necessary to adjust the length of the wires.
Ensure maximum care is taken when connecting wiring.
Make professional joints using solder and shrink sleeve. Do not stretch the wiring harness.
No component of the LPG-system shall be located within 100 mm of the exhaust or similar heat
source, unless such components are adequately shielded against heat.
If holes have to be drilled (wear safety glasses) for installing brackets, etc., the drilled holes must always be treated
with an anti-corrosion agent, after the chips have been removed ( especially when mounting a exterior filler into body work).
After having completed the installation, check the whole system for LPG leakage; use a LPG leak detection device.
Also check for leak of engine coolant, petrol and air.
Fitting and maintenance is only allowed by Prins Autogassystemen selected LPG engineers.
Failure to follow the instructions in this manual can result in a poor or non-working LPG installation or a dangerous situation.
For maintenance instructions see owner manual.
Prins Autogassystemen is not responsible for any damages to people or objects as a result of changes to Prins products.
Check our website regularly for diagrams, certificates, updates, info-bulletins and product information.
General instructions
Register ( warranty card ) the system on the Prins warranty portal .
076/0705500
Copyright © Prins Autogassystemen B.V. 2014
Advertisement
Table of Contents
