M-system KSE-1 Instruction Manual

INSTRUCTION MANUAL
(dial adjustment; single trip)

BEFORE USE ....

Thank you for choosing M-System. Before use, check the
package you received as below.
If you have any problems or questions with the product,
please contact M-System's Sales Office or representatives.

PACKAGE INCLUDES:

Signal conditioner (body + base socket + input resistor) (1)
Input Resistor is provided only with current input type.

MODEL NO.

Check that model No. described on specification label is
exactly what you ordered.
INSTRUCTION MANUAL
This manual describes necessary points of caution when you
use this product, installation, connection and basic mainte-
nance procedures.

COMPONENT IDENTIFICATION

Connection Diagram
Label
Specification
Label
Mo del K SE
10 0
50
0

FRONT PANEL CONFIGURATION

50
DC ALARM
Base Socket
Body
Input Resistor
%
Hi Monitor LED
100
%
Hi Setpoint Adj. Dial
0
MODEL

INSTALLATION

Detach the yellow clamps lo-
cated at the top and bottom of
the unit for separating the body
from the base socket.

DIN RAIL MOUNTING

Set the base socket so that its
DIN rail adaptor is at the bot-
tom. Position the upper hook
at the rear side of base socket
on the DIN rail and push in the
lower. When removing the
socket, push down the DIN rail
adaptor utilizing a screwdriver
(–) and pull.

WALL MOUNTING

Refer to the drawings in the following page.

TERMINAL CONNECTIONS

Connect the unit as in the diagram in the following page or
refer to the connection diagram label on top of the unit.
When an input resistor is provided with the module, attach
it together with input wiring to the input screw terminals.
KSE- 1
KSE- 1
Clamp
(top & bottom)
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
Shape and size of the base socket
are slightly different with various
socket types.
P. 1 / 3 EM-3609-A Rev.1