Removing The Aa-04 From The Wall - Lasermet Audio Alert AA-04 Instruction Manual

AA-04 Audio Alert Instruction Manual

Removing the AA-04 from the wall

Once the AA-04 has been locked to the wall, a 5mm flat screwdriver is required to
release the locking latch before it can be removed, see figure 8.
01379-53-000
Ensure that the supply is turned off.
Insert the screwdriver into the recess in the
bottom of the AA-04 at the back and push the
latch upwards to disengage it from the case.
Note that the latch is quite secure and some
force may be needed before it releases.
When the latch is released it will be possible
to tilt the bottom of the AA-04 forwards and
then lift it off the backplate.
Use a 3mm flat screwdriver to disconnect the
wires from the terminals.
Figure 8: Releasing
Locking Pin
Page 13 of 14
th
Issue 2 25 February 2014