Advertisement
Quick Links
I
F
U
Carriage with "Pivot Handle"
nstructions
or
se
Disassembly & Assembly
De Mayo V2
Knee Positioner
®
®
K
ALL C
O
E
K
P
T
.
EEP
OMPONENTS
F
ACH
NEE
OSITIONER
OGETHER
NOT
Do
MIX & MATCH THE COMPONENTS OF DIFFERENT POSITIONERS.
Disassembly
1. Unscrew and remove the E-stop.
Remove the E-stop by turning it
counter clockwise.
Advertisement
Related Manuals for IMP De Mayo V2 Knee Positioner
Summary of Contents for IMP De Mayo V2 Knee Positioner
- Page 1 Carriage with “Pivot Handle” nstructions Disassembly & Assembly De Mayo V2 Knee Positioner ® ® ALL C OMPONENTS OSITIONER OGETHER MIX & MATCH THE COMPONENTS OF DIFFERENT POSITIONERS. Disassembly 1. Unscrew and remove the E-stop. Remove the E-stop by turning it counter clockwise.
- Page 2 Pivot Handle I F U pg.2 2. Remove the boot and then slide and remove the varus tilt control. 3. Straighten, and then turn the Handle counter clockwise to remove the Handle. 4. Slide the carriage to the “CE” mark end of the base plate, and rotate the carriage off The carriage will open, but does not disassemble any further.
- Page 3 Assembly Pivot Handle I F U pg.3 1. With the hole for the handle facing you, rotate and slide the carriage onto the “CE” mark end of the base plate. Slide the carriage around the curve of the base plate to fully seat it. 2.
- Page 4 Pivot Handle I F U pg.4 4. Thread the E-Stop into the carriage. 5. Proper location of the Handle. Start with the Handle in the unlocked (10 o’clock) position and, insert the boot. Tighten the Handle to the locked (2 o’clock) position. Do NOT mix &...