Seatra Stabil-Mate Owner's Manual

Hydraulic stabilising system for caravans

Advertisement

Replace those binding,
tight, hard-to-wind
corner stabilisers.
No more kneeling
and bending.
Easy to use – operated
from a central control.
Can be tted by a
handyman, caravan
repairer or adequate
workshop.
OWNER'S MANUAL
Please familiarise yourself with this manual before using
STABIL-MATE to prevent damage to property or personal injury.
More information https://www.caravansplus.com.au

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stabil-Mate and is the answer not in the manual?

Questions and answers

Summary of Contents for Seatra Stabil-Mate

  • Page 1 Easy to use – operated from a central control. Can be tted by a handyman, caravan repairer or adequate workshop. OWNER’S MANUAL Please familiarise yourself with this manual before using STABIL-MATE to prevent damage to property or personal injury. More information https://www.caravansplus.com.au...
  • Page 2 IMPORTANT PLEASE READ BEFORE INSTALLATION FITTING INSTRUCTIONS FOR YOUR STABIL-MATE HYDRAULIC STABILISING SYSTEM • A handyman or a caravan repairer can fit this stabilising system. • Please note: No copper tube or oil are supplied with this stabilising system. • When fitting this unit please ensure all brass fittings are tight by using either thread-tape or a hydraulic thread locker.
  • Page 3 • This unit should not require bleeding. It will purge the air from the system each time it is used. • Once your Stabil-Mate has been installed, when the legs are down it should look the same as shown in Diagram D.
  • Page 4 We have designed this product for long term e ciency. Manufactured by: Seatra International Pty Ltd 233 Shepherds Hill Road, Eden Hills, South Australia, 5050 Phone: (08) 82785107 Fax: (08) 82789269 Email: seatra@iweb.net.au More information https://www.caravansplus.com.au...
  • Page 5 OPERATING INSTRUCTIONS FOR YOUR STABIL-MATE HYDRAULIC STABILISING SYSTEM • Once you have positioned your caravan on site, engage the caravans parking brake and chock wheels. • Close release valve and open the four remaining valves, which go to the legs and proceed to pump the handle until all legs touch the ground.
  • Page 6 More information https://www.caravansplus.com.au...
  • Page 7 (LH ASSEMBLY ILLUSTRATED) More information https://www.caravansplus.com.au...
  • Page 8 ™ Manufactured by: SEATRA INTERNATIONAL PTY LTD 233 Shepherds Hill Rd, Eden Hills SA 5050 Ph: 08 8278 5107 Fax: 08 8278 9269 Email: seatra@iweb.net.au More information https://www.caravansplus.com.au...

Table of Contents