Advertisement
Advertisement
Summary of Contents for CHAMELEON Retractable Hose System
- Page 1 Finishing & Operating Instructions Attention Installer: Please be sure this manual and warranty information are left with the customer when installation is complete. 512 West Gorgas Street § Louisville, OH 44641-3912 www.chameleonvac.com Dealer Name Dealer Phone 80205 • 5/19...
-
Page 2: Table Of Contents
TABLE OF CONTENTS: General Information ..................3 Completing the Installation ................3 Installing the Hose into the Valve ..............4 Shortening the Hose ..................5 Using the System ................... 6 Storing the Hose .................... 7 Warranty ......................8... -
Page 3: General Information
GENERAL INFORMATION The Chameleon Retractable Hose System for central vacuums is designed for home and light commercial interior installations. The Chameleon Valve solves the challenge of storing and retrieving the long hose typically used with central vacuums. Hoses are available in lengths up to 60’ to offer maximum cleaning coverage and optimum valve location no matter the floor plan of the home. -
Page 4: Installing The Hose Into The Valve
Multiple Valve Installation Tip: It is necessary to leave the red plug securely in place in all valves until the hoses are installed to allow the system to seal. Only a sealed Red Cap system will have the adequate Installed vacuum to retract the hose into a valve when a hose is being installed. -
Page 5: Shortening The Hose
SHORTENING THE HOSE 1. Locate the tabs on each side of the handle’s underside. (FIG. 1) 2. Use a screwdriver or fingernail to press tabs in towards the hose to release and remove the handle. (FIG. 1) 3. Keep the black locking collar on the hose. (FIG. 2) 4. -
Page 6: Using The System
USING THE SYSTEM 1. Pull hose handle out, down and away from the valve. (FIG. 1) 2. Continue pulling the hose until you feel the end of the hose reach the valve. You will hear and feel the hose end “click” into its locked position. (FIG. -
Page 7: Storing The Hose
STORING THE HOSE 1. With the system on, unlock the hose end by grabbing the hose approximately 8-inches from the valve and rotate the hose to the left until it releases. (FIG. 1) 2. Partially cover the handle end with hand to retract the hose. (FIG. 2) 3. -
Page 8: Warranty
(3) years from original date of consumer purchase. In the event of a defect in the Chameleon Hose, it will be repaired or replaced, at H-P Products' option, at an Authorized Dealer’s location at no cost to you.