MORDOMUS iZRC-2 Manual

MORDOMUS iZRC-2 Manual

Z-wave

Advertisement

Quick Links

Z-Wave Remote iZRC-2/8/P
iZRC-2
iZRC-8
The Remote PSR03 is a simple control can control AV device through Z-
Wave-to-IR extender, and it can also controls 8 lighting groups ON/OFF
via basic set, based on Z-Wave
It is the Z-Wave
TM
plus product, it support the security, OTA... Those
newest features of the Z-Wave
communication protocol designed for home automation, specifically to
remotely control applications in residential and light commercial
environments. The technology uses a low-power RF radio embedded or
retrofitted into home electronics devices and systems, such as lighting,
home access control, entertainment systems and household appliances.
This product can be included and operated in any Z-Wave
with other Z-Wave
TM
certified devices from other manufacturers and/or
other applications. All non-battery operated nodes within the network
will act as repeaters regardless of vendor to increase reliability of the
network.
iZRC-P
TM
technology.
TM
technology. Z-Wave
TM
is a wireless
The device adopts the Z-Wave
network system is all made by Z-Wave
network system will have the advantages as below.
Concurrent multi-channel support reduces external interference.
Better RF range, improve about 10 meters in indoor.
Support 100 Kbps transmit speed, speed up communication.

Function Compare 2/8/P

iZRC-2
iZRC-8
iZRC-P
Adding to Z-Wave
In the first time, activate the device through micro USB, then it can be
added into the Z-Wave
controller is in the add mode. And then power on the device. The
device will auto start the NWI (Network Wide Inclusion) mode. And it
should be added in 5 seconds. You will see the LED light ON one
second.
Function

Add

TM
network
1
www.mordomus.com
TM
500 series chip, when your Z-Wave
TM
Group
AV Control
Control
V
V
V
V
TM
Network
TM
network.
First, make sure the primary
Description
1. Have Z-Wave
TM
Controller entered add mode.
2. Hold down the central key, then press the top-right
key three times within 1.5 seconds to enter the add
mode.
Note: iZRC-P is added by pressing panic key
TM
500 series devices. The
Panic
V
V
V

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iZRC-2 and is the answer not in the manual?

Questions and answers

Summary of Contents for MORDOMUS iZRC-2

  • Page 1 Z-Wave Remote iZRC-2/8/P The device adopts the Z-Wave 500 series chip, when your Z-Wave network system is all made by Z-Wave 500 series devices. The network system will have the advantages as below. Concurrent multi-channel support reduces external interference. •...
  • Page 2 3. After add successful, the device will wake to maximum. receive the setting command from Z-Wave iZRC-2 supports 3 groups. The group 1 is for Controller about 20 seconds. receiving the report message. Group 2, 3 are for lighting group control. Each group supports 4 nodes.
  • Page 3 Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from • that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for • help. www.mordomus.com...

This manual is also suitable for:

Izrc-8Izrc-p

Table of Contents