Table of Contents
Advertisement
Available languages
Available languages
Electrical Connections
E
N
G
L
I
S
H
Cautions:
• This product is designed to operate with a 12 V DC, negative ground battery system.
19
• To prevent damage to the unit, be sure to follow the connection diagram below.
• Strip about 5 mm of the lead ends for connection.
• Do not insert the power connector into the unit until the wiring is completed.
• Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
• Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
Supplied hardware
No.
Item
y
Power connector
Wiring Diagram
Preamp output connector (rear)
CQ-DP133U/DP103U/DPX153U
L (White)
R (Red)
Antenna
y
Power connector
Ground lead
(Black)
To a clean, bare metallic
part of car chassis.
Motor antenna
relay control lead
(Dark blue)
(To motor antenna)
(Max. 500 mA)
This lead is not intended
for use with switch actuated
power antenna.
Note: The power antenna extends
automatically when the FM/AM
radio mode is selected.
FRONT SP
(White/
(White)
(Gray/black
(Gray)
black
stripe)
stripe)
(–)
(+)
(–)
(+)
Left speaker
Right speaker
(Front)
(Front)
28
CQ-DP133U/DP103U/DPX153U
Q'ty
1
Only for CQ-DP133U/DPX153U
Only for CQ-DPX153U
Preamp output
Sub-Woofer Cord (Monaural)
connector (front)
(Red)
S.W.OUT
(White)
Fuse (15 A)
C
C
If the fuse (rear panel) blows frequently, they may
be something wrong with the unit or wiring. Consult
your nearest Panasonic Servicenter for service.
Battery lead
BATTERY 15A
To the car battery, continuous +12 V DC
(Yellow)
Power lead
ACC
To ACC power, +12 V DC
(Red)
Amp. relay control power lead
(Max. 500 mA)
(Dark blue/
This lead is for connection to the power
white stripe)
amplifier.
Note: This lead is used for power
control when an external power
amplifier is connected. The power
supply of a power amplifier will be
activated when turning on the power of
Speaker lead
this unit.
REAR SP
(Green/black
(Green)
(Violet/black
(Violet)
stripe)
stripe)
(–)
(+)
(–)
(+)
Left speaker
Right speaker
(Rear)
(Rear)
Specifications
General
Power supply:
12 V DC (11 V–16 V), test voltage 14.4 V, negative ground
Current consumption:
Less than 2.2 A (CD play mode; 0.5 W 4 channels)
Maximum power output:
45 W 4 channels at 1 kHz, volume control maximum
Tone adjustment range:
Bass:
±12 dB at 100 Hz
Treble:
±12 dB at 10 kHz
Suitable speaker impedance: 4–8
Preamp output voltage:
2.5 V (CD play mode; 1 kHz, 0 dB)
Output impedance:
200
Dimensions (W H D):
7" 1
15
/
" 5
7
/
" (178 50 155 mm)
16
8
Weight:
3 lbs. 1 oz (1.4 kg)
FM Stereo Radio
Frequency range:
87.9 MHz–107.9 MHz
Usable sensitivity:
11.0 dBf. (1.25 µV, 75 )
50 dB quieting sensitivity:
15.2 dBf. (1.6 µV, 75 )
Frequency response:
30 Hz–15 kHz (±3 dB)
Alternate channel selectivity: 75 dB
Stereo separation:
42 dB (1 kHz)
Image response ratio:
75 dB
IF response ratio:
100 dB
Signal/noise ratio:
70 dB
AM Radio
Frequency range:
530 kHz–1 710 kHz
Usable sensitivity:
28 dB/µV (25 µV, S/N 20 dB)
CD Player
Sampling frequency:
8 times oversampling
DA converter:
1 bit DAC system
Error correction system:
Panasonic super decoding algorithm
Pick-up type:
Astigma 3-beam
Light source:
Semiconductor laser
Wave length:
780 nm
Frequency response:
20 Hz–20 kHz (±1 dB)
Signal/noise ratio:
96 dB
Total harmonic distortion:
0.01 % (1 kHz)
Wow and flutter:
Below measurable limits
Channel separation:
75 dB
Above specifications comply with EIA standards.
Note: Specifications and the design are subject to modification without notice due to improvements in technol-
ogy.
E
N
G
L
I
S
H
20
29
CQ-DP133U/DP103U/DPX153U
Hide quick links:
Advertisement
Table of Contents
