Initial Use - Princess 283069 Manual

Initial use

Warning!
­ Before first use, allow the appliance to sit
for at least 3 hours. The coolant first has to
settle in the cooling element.
• Clean the appliance. Refer to the section
"Cleaning and maintenance".
• Clean the accessories. Refer to the section
"Cleaning and maintenance".
Use
Setting the time (fig. B)
Real time
• Press the time button (13) 1x to set the
hours. The real­time indicator (17) comes
on. The hour digits of the time indicator
(16) start to flash. Press the arrow button
(14) to adjust the hours.
• Press the time button (13) 2x to set the
minutes. The minute digits of the time
indicator (16) start to flash. Press the arrow
button (14) to adjust the minutes.
Power-on time
• Press the time button (13) 3x to set the
hours. The power­on time indicator (18)
comes on. The hour digits of the time
indicator (16) start to flash. Press the arrow
button (14) to adjust the hours.
• Press the time button (13) 4x to set the
minutes. The minute digits of the time
indicator (16) start to flash. Press the arrow
button (14) to adjust the minutes.
Power-off time
• Press the time button (13) 5x to set the
hours. The power­off time indicator (19)
comes on. The hour digits of the time
indicator (16) start to flash. Press the arrow
button (14) to adjust the hours.
• Press the time button (13) 6x to set the
minutes. The minute digits of the time
indicator (16) start to flash. Press the arrow
button (14) to adjust the minutes.
Setting the ice cube size (fig. B)
• Press the ice­cube size button (12) 1x to
make small ice cubes. The ice­cube size
indicator (20a) comes on.
• Press the ice­cube size button (12) 2x to
make medium ice cubes. The ice­cube size
indicator (20b) comes on.
• Press the ice­cube size button (12) 3x to
make large ice cubes. The ice­cube size
indicator (20c) comes on.
Hints for use (fig. A & B)
Caution!
­ Do not switch on the appliance within
3 hours after moving the appliance.
­ Make sure that there is sufficient space
around the appliance to allow heat to
escape and provide sufficient ventilation.
Minimum distance from the air inlet and
the air outlet: 20 cm.
­ Only use tap water to fill the water reservoir.
­ Do not exceed the maximum mark (5,
"H­MAX") when you fill the water reservoir.
• Place the appliance on a stable and flat
surface.
• Open the lid (2).
• Fill the water reservoir (4) with the
required amount of water.
Note: It is recommended to add 1 tablespoon
of lemon juice each time you fill the water
reservoir. The lemon juice releases a fresh citrus
smell throughout your home. The acid in the
lemon juice will combat the growth of bacteria,
mould and airborne allergens.
• Place the ice cube reservoir (6) into the
appliance.
• Close the lid (2).
• Insert the mains plug into the wall socket.
The display (15) comes on.
• If you want to use the timer function, set
the power­on time and the power­off time.
Refer to the section "Setting the time".
• Set the required ice cube size. Refer to the
section "Setting the ice cube size".
• To switch on the appliance, press the
on/off/standby button (11). The ice­cube
making indicator (21) starts to flash. The
appliance starts making ice cubes.
• Within 15 minutes, the appliance is at the
correct temperature and the first ice cubes
are ready. As long as the appliance is switched
on, it will continue to produce 12 ice cubes
every 9­13 minutes (depending on the size).
12