Intel DH61CR Setting Manual

Intel DH61CR Bios Settings

Setting the Computer BIOS (CMOS), DH61CR Motherboard

This procedure applies only to systems with the Intel
System Computer has a different motherboard, check
information.
If you are comfortable using the CMOS Setup Utility, connect a keyboard to the computer and
press the F2 key during boot to run the utility. Press F9 or select Load BIOS Defaults from the
Exit Menu, press Y to confirm, and then change the settings shown in the table below. For more
help, refer to the detailed instructions that follow.

Menu

Press F9 to Load BIOS Defaults

Main
Configuration
Power
Boot
Important: Your screens may not look exactly like the screens shown in this document, and some
settings shown on the screens examples may be different from your system.
Do not change any settings that are not specifically described in this document.
Note: Use the left and right arrow keys (→←) to move between the menus listed at the top of the
screen, and the up and down arrow keys (↑↓) to move up and down between menu items. Use the +
and – keys to change settings for selected items.
1. Press the F2 key during boot. The System Setup Utility Main Menu will appear.
2. Press the F9 key to Load Bios Defaults, and then press Y to confirm. Now change the BIOS settings
described on the following pages.
Page 1 of 3
Submenu Item
(If Applicable)

System Date

System Time

SATA Drives

Chipset SATA Mode

After Power Failure

Boot Device Priority

®
DH61CR Motherboard. If your
http://service.globalvr.com
Setting
Set to Current Date
Set to Local Time
IDE
Power On

Optical Drives

Removable Drive

Hard Disk Drives

Network
for updated
©2013 Global VR Inc.