Page 3
Main module(A) Mounting rail(B) Insert rail(C) Plastic profile Hinge ring Screw for hinge ring M4x25 Nuts for hinge ring M4 Hand crank We recommend that the screen (s) are always rolled up when the pergola is not in use, due to weather and wind.
Page 4
1. Assemble the mounting rails and main module Attach the mounting rails (B) to the end of the main module (A) as on the sketch below. right mounting rail main frame left mounting rail...
Page 5
2. Lift the main module up and move it into the mounting area The main module (A) is held up by the two frame rail (B). Place the main moudle where it is to be mounted.
Page 6
3. Mount on pergola cross section pergola pergola rail(B)
Page 7
4. Mount the plastic profile/fabric Attach the fabric to the frame on both sides. 1. Make sure the mounting rails (B) stands straight before the fabric into the plastic profile. section of plastic profile mounting rail(B) mounting rail(B) plastic profile plastic profile 2.
Page 8
After the plastic profile is installed, pull down the fabric to adjust it before installing the insert rails.
Page 9
6. Mount insert rail insert rail(C) mounting rail(B) mounting rail(B) mounting rail(B) insert rail(C) mounting rail(B) plastic profile insert rail(C) plastic profile TIP! Use a rubber hammer to hit insert rail(C) gently from bottom to top, if any difficult to get the insert rails in place.
Page 10
7. Mount hinge ring 2. Screw M4x25 with hinge ring 3.Lock with nut M4 1. Insert the hinge ring into the gearbox shaft...
Page 11
8. Turn the hand crank to operate Put hand crank into hinge ring...
Need help?
Do you have a question about the AC153000 and is the answer not in the manual?
Questions and answers