Chevrolet Tahoe 2018 Getting To Know Your page 4

REMOTE KEYLESS ENTRY TRANSMITTER (KEY FOB)
Unlock
Press to unlock the driver's door.
Press again to unlock all doors.
Lock
Press to lock all doors.
Press and hold the Lock/Unlock buttons
to automatically fold/unfold the power
mirrors .
F
Note: To change the Auto Mirror Folding
setting, go to Settings > Vehicle > Comfort and
Convenience.
Liftglass
F
Press twice to open the liftglass.
Power Liftgate
Press twice to open or close the power
liftgate.
Vehicle Locator/Panic Alarm
Press and release to locate your vehicle.
Press and hold to activate the alarm.
Press again to cancel the alarm.
HANDS-FREE PROGRAMMABLE POWER LIFTGATE
OPEN/CLOSE THE POWER LIFTGATE
Power Liftgate button on
Press the
the RKE transmitter twice.
Power Liftgate knob on
Press the
the overhead console.
Press the touchpad on the liftgate
handle to open the liftgate.
Press the button next to the liftgate
latch to close the liftgate.
HANDS-FREE OPERATION
To open or close the liftgate hands-
free, kick your foot straight in and out
under the center of the rear bumper.
Do not swing your foot side-to-side.
The Remote Keyless Entry transmitter
must be within 3 feet of the liftgate.
4
Optional equipment
F
F
F
Remote Vehicle Start
Press and release the
and then press and hold the
until the turn signal lamps flash (about
4 seconds) to start the engine from
outside the vehicle. After entering the
vehicle, turn on the ignition.
• During a remote start, the engine will
run for 10 minutes.
• Remote Start can be extended once by
repeating the remote start procedure.
• Press and hold the
the parking lamps turn off to cancel a
remote start.
• The heated/ventilated seats
on during a remote start (if selected in
the Vehicle Settings menu) when out-
side temperatures warrant.
Note: If a key fob is left in the vehicle when
locking the vehicle, the Remote Left in Vehicle
Alert may sound. To change the remote lock,
unlock, and remote start settings, go to Settings
> Vehicle > Remote Lock, Unlock, Start.
See Keys, Doors and Windows in your Owner's Manual.
PROGRAMMING THE LIFTGATE HEIGHT
1. Turn the Power
Liftgate knob
to the 3/4 mode
position.
2. Open the liftgate.
3. Adjust the liftgate
manually to the
desired height.
4. To save the setting, press and hold the
button next to the liftgate latch for
3 seconds. The turn signals will flash
when the setting is saved.
See Keys, Doors and Windows in your Owner's Manual.
F
Lock button
button
button until
will turn
F
F