Initial Setup For Basic Connections (Ready To Play) - Panasonic Omnivision PV-D4733S Operating Instructions Manual

Initial Setup for Basic Connections (Ready to Play)

Before doing Initial Setup
1
Turn TV on.
2
See connections
<RF Coaxial Cable Connection>
Set TV to channel 3.
<AV Cable Connection>
Set TV to VIDEO.
[DECK ➛ ➛ ➛ ➛ ➛ TV]
3
• Go to "Doing Initial Setup (Ready to Play)." (See below.)
[Cable Box ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV], [DSS ➛ ➛ ➛ ➛ ➛ DECK ➛ ➛ ➛ ➛ ➛ TV]
• Turn on Cable Box and set it to your Public Broadcasting Station (PBS) channel
in your time zone.
• If you use a DSS Receiver, it must be turned off.
Doing Initial Setup (Ready to Play)
1
Press VCR on remote for VCR mode.
2
Plug DECK Power Cord into AC wall outlet. DECK comes on and auto channel
and clock set starts.
• If screen below does not appear, check DECK - TV connection and, if TV is tuned to
channel 3, try switching it to channel 4.
• To change VCR's output channel, please refer to "VCR's Output Channel" on p. 19.
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
CANCEL : STOP
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
16
a
RF Coaxial Cable Connection and
Plugging the AC Power Plug into
an AC outlet
• Function buttons are inoperative during Initial Setup.
• To remove a cassette during Auto Set, press EJECT on
• Depending on conditions, Auto Clock Set may take longer
PROCEEDING
Notes
the remote or STOP/EJECT twice on the DECK.
In this case, settings must be made manually. (See p. 18.)
than 30 minutes. If so, press STOP to stop setup and
perform settings manually. (See p. 18.)
b
AV Cable Connection on p. 12.
Continued on next page...