How Does That Feel; Changing To A Shorter Strap; Changing To The Locking Strap; Attaching The Vega To A Belt Clip - O2health Vega Manual

How does that feel?

Your Vega comes attached to a long strap. If you decide it's too big for your
wrist, you want to lock the Vega on to your wrist, or you want to use the belt clip
instead, follow the instructions below.
If you can't do this for yourself, you can ask someone from the
organisation that gave you the Vega to do it for you.
What you should have in your pack: one Vega (attached to a support with four
screws and two straps, one belt clip, one short clip strap, two straps with oval
holes in (one long, one short), one locking clip strap, one piece of plastic with two
small holes, one key (a plastic key tool with two prongs), one screwdriver, two
short screws and one steel pin.

Changing to a shorter strap

Your Vega comes attached to a long strap with oval holes and a short buckle strap.
In your pack you'll also get a shorter strap with oval holes. If you want to change
to the shorter strap follow these instructions.
1. Unclip the longer strap by putting the key into the two holes in the support,
then pulling the strap out.
2. Get the shorter strap and push it into the support until it clips.
11

Changing to the locking strap

There are two straps with holes in – a long one and a short one. You'll need to
pick the best fit for you. If you need to change it, follow these instructions:
1. Use your screwdriver to take out the four screws from the back of the support.
2. Once you've done that, take the support away from the Vega.
3. Remove the shorter strap by taking the steel pin out of the part that's attached
to the support. Bear in mind it might be quite difficult to do the first time.
4. Get your chosen strap with holes in and push it through the holes in the
support.
5. Feed the steel pin through the small holes at the end of the strap to keep it in
place. Again, it might be quite difficult to do the first time.
6. Put the Vega on the support.
7. Screw in the four screws on the back of the support.
8. Unclip the longer strap by putting the key into the two holes in the support,
then pulling the strap out.
9. Clip the locking strap in to the support.
10. Fit the strap around the wearer's wrist to find the best fit.
11. Line up the gold metal holes on the locking strap with the holes on the other
strap.
12. Place the piece of plastic with two small holes over the lined-up holes.
13. Take out the locking strap using your key. This is to give you the space to screw
it into place.
14. Screw in two short screws using the screwdriver.
15. Put it round your wrist and clip the strap into the support.

Attaching the Vega to a belt clip

1. Use your screwdriver to take out the four screws from back of the support.
2. Once you've done that, take the support away from the Vega.
3. Place the belt clip on the back of the Vega, lining up the four holes in the
corners.
4. Screw the four screws into the four holes on the back.
5. Slide the clip onto your belt.
12