Advertisement
ASSEMBLY - STEP 5
Install the handlebar support frame (J) into the console tube (K), and attach the upper spinner
to lower spinner in console tube (see picture 1). Next, connect the cable in console tube (K) to
matching cable of the cart (see picture 2). Slide the console tube to cart, and connect them
with four MB x 16 mm screws (7) and four
them using 5 x 5 mm hex key tool (6). Then attach the console mast (J) to the cart.
K
11
7
2
ASSEMBLY - STEP 6
Plug the handle bar tube (M) into the console, making sure the pulse sensor is down-forward.
Tighten knob (F). Connect the console module (L) to console tube by using M5 x 8 mm screws (10).
L
10
8 x 19 washers (2), four spring washers (11). Lock
J
M
F
picture 1
Link the two cables with white joint to handle
tube (M). Link the third cable of the console
to the console tube. Finally, adjust the
console position and tighten it in place using
screwdriver (4) and M5 x 8 mm screws (10).
1
2
3
4
picture 2
pulse sensor
Advertisement
