Subscribe to Our Youtube Channel
Summary of Contents for Braemar ER900
- Page 1 Braemar, Inc. ER900 ER900 ER900 ER900 ER900 AF ER900 AF ER900 AF ER900 AF Arrhythmia Event Monitor Caution: U.S. Federal law restricts this device to sale by or on the order of a physician.
- Page 2 Excluded from this warranty are expendable supply items including, but not limited to, electrodes, leadwires, patient cables and batteries. This warranty does not apply to any product that Braemar determines has been modified or damaged by the customer. Except for the express warranties stated above, Braemar disclaims all warranties including implied warranties of merchantability and fitness.
-
Page 3: Table Of Contents
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Table of Contents Overview....................3 Indications for Use ..................3 Precautions....................3 This page intentionally left blank. Monitor Components ................4 Setup Steps ....................5 Notes about Monitor Preparation:.............5 Monitor Preparation (done by trained Technician) .......6 Electrode Application and Patient Hookup..........9... -
Page 4: Overview
Event recording is activated by the patient or by automatic event detection. The ER900 provides up to 30 minutes of total recording time and will operate for up to 30 days with two AAA Alkaline batteries. Four pre-programmed recording options are available. Other selectable options include audible event record, lead loss detect, pacer detect, X3 transmission, and automatic record on arrhythmia detect. -
Page 5: Setup Steps
This manual is designed to allow a technician to follow the instructions removing the battery door. Set the programming option switches for page by page to setup the ER900 and ER900 AF monitor. Here is the your desired options according to the following table. - Page 6 ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Monitor Preparation (continued) The patient cable should not be installed at this time. Install two fresh AAA Alkaline batteries. Observe proper battery polarity. Upon completion of the self-test the monitor will sound one of the following tones: This page intentionally left blank.
-
Page 7: Electrode Application And Patient Hookup
Patient Operating Instructions Electrode Application and Patient Hookup The ER900 or ER900 AF monitor should be ready when you receive it The Monitor Preparation section must be completed before proceeding. from the technician. If there are any problems, refer to the Troubleshooting section. -
Page 8: This Page Intentionally Left Blank
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors To Send: Remove the patient cable from the monitor. Set the monitor on a flat surface with the speaker hole up. Call the receiving center. A. Cell phones and VOIP phones do not work for the transmission. -
Page 9: Troubleshooting
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Event Markings Troubleshooting Symptom Recommended solution The following shows typical event markings that are generated by the No single beep when inserting Install batteries or check battery direction. -
Page 10: Service & Maintenance
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Service & Maintenance Equipment Symbols Cleaning Symbol Description Remove the batteries before cleaning the recorder. Clean the battery Type B Applied Part terminals with a soft dry cloth. Dampen a soft cloth with mild detergent and water to clean the recorder, lead wires, and belt clip. -
Page 11: Specifications
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Additional equipment classification information as required in EN 60601-1 A. EQUIPMENT not suitable for use in the presence of a Specifications FLAMMABLE ANAESTHETIC MIXTURE WITH AIR of WITH... -
Page 12: Electromagnetic Emissions
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Electromagnetic Emissions Electromagnetic Emissions test Compliance environment - guidance RF emissions Group 1 The ER9xx uses RF energy only CISPR 11 for its internal function. Therefore, its RF emissions are very low and... -
Page 13: Recommended Separation Distances
ER900 and ER900 AF Event Monitors ER900 and ER900 AF Event Monitors Recommended Separation Distances Refer to the following table for recommended separation distances between the ER9xx and portable and mobile RF communications equipment. The ER9xx is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. - Page 14 Braemar Inc. Phone: 800.328.2719 1285 Corporate Center Drive, Suite 150 Fax: 651.286.8630 Eagan, MN 55121 USA E-Mail: Service@BraemarInc.com Copyright 2006, Braemar Inc. All rights reserved...
Need help?
Do you have a question about the ER900 and is the answer not in the manual?
Questions and answers