Advertisement
Quick Links
Advertisement
Related Manuals for ATON Ra.Store-K
Summary of Contents for ATON Ra.Store-K
- Page 1 Installation of the Wi-Fi communication card Rev. 1.01 Ra.Store-K...
- Page 2 Follow the below procedure to modify the communication mode of storage system model Ra.Store-K and to install the Wi-Fi ATN813 communication card: Switch the storage system off according to the following procedure: Open FB1, FPV1, FPV2 and Switch OFF QG1, QE2 and QE21 on the equipment’s side.
- Page 3 Gently pull the panels’ upper part so that the pins get out of the guides. Lift the panel. The control card is located in the equipment’s upper part. Disconnect the connector on the “flat ribbon” that feeds the external led column as indicated in the following picture.
- Page 4 3. Remove the GPRS communication card and install the Wi-Fi communication card: 1) Remove the plastic protection on the card’s back by unscrewing the two nuts that keep it fixed to the display card. 2) Unscrew and disconnect the golden connector that connects the aerial’s coaxial cable to the communication card.
- Page 6 4) Insert Wi-Fi ATN813 card in slot n.1. 5) Connect the coaxial golden connector to the plug on the Wi-Fi ATN813 card, which has been inserted in Slot 1 of the display card 6) Replace the plastic protection by screwing the two nuts that keep it fixed to the display card.
- Page 7 Modification of the system’s Wi-Fi connectivity The picture here below show the display and the system’s keys. Press the “arrow up” key until displaying the screen with numerical data. While pressing the orange-circled key, press the “Enter” key (green). This procedure allows accessing the main-configuration menu.
- Page 8 Move the cursor beside the “Wi-Fi” writing using the “arrow up” and “arrow down” keys. Press “ENTER”. The following picture shows the Wi-Fi submenu: The cursor is positioned next to the writing “Start”; press the “ENTER” key to enable the Wi-Fi communication. The first writing of the Wi-Fi menu changes from “WIFI OFF”...
- Page 9 The following screens will appear after a few seconds: meaning that the Wi-Fi communication is enabled. In order to complete the configuration procedure, use any device with a Wi-Fi connection (here below referred as PC) and Web Browser: 1. Connect the PC to the Wi-Fi net Ra_Config (Pic. 5). 2.
- Page 10 NOTE: in case it appears a screen with a red box (see following pic) at any point of the procedure, go back to point 1.
- Page 11 4. In the Network Mode field, select Client (Infrastructure) (Pic. 8). 5. Click on the Refresh List key. The module will scan the available nets and will show the relevant list in Available Access Points (Pic. 8). 6. Select a net; fields Access Point SSID and Security Mode (for Wi-Fi nets with no password, select “Open”) will be automatically filled.
- Page 12 8. (Optional) the module uses the DHCP as a default. To set a static IP, remove the tick to Check to enable DHCP and enter a static IP, subnet mask, and gateway. 9. Click on Save & Reboot to save the settings. 10.
Need help?
Do you have a question about the Ra.Store-K and is the answer not in the manual?
Questions and answers