Do you have a question about the Airtester HP and is the answer not in the manual?
Questions and answers
Summary of Contents for MSA AUER Airtester HP
Page 1
Airtester HP for compressed air according to EN 12021 Instruction for use Part Number D3188001 (Edition Dec. 2003)
Page 2
Choice and use are beyond the control of MSA AUER GmbH. Therefore, the liability of MSA AUER GmbH covers only the consistant quality of this product. The above does not alter statements regarding the warranties and conditions of sale and deliveries of MSA AUER GmbH.
Instruction for use 1. Use The compressed air monitoring set ”MSA AUER Airtester HP” (HP = high pressure) is used to determine the content of carbon monoxide, carbon dioxide, oil and water vapour in respirable air from compressors and compressed gas cylinders.
Page 4
The air has than a higher water content as measurements. was measured on the compressor charging panel. Liquid water (droplets) can only be removed from the MSA AUER compressors normally have a pressure test device through long flushings with dry, if retaining valve. necessary warm air.
Page 5
point away from the test device. Fig. 3: Breaking off detector tube tips Fig. 4: Inserting detector tube into detector tube holder Fig. 5 :Flowmeter during Measuring Fig. 2: Setting flow rate on flowmeter - 5 -...
Page 6
Detector tubes Oil- HP synth.* D5085850 In case of other disorders the device should be returned for repair to MSA AUER or any authorized Test device D4074937 service station. Gaskets for connector to cylinder...
Need help?
Do you have a question about the Airtester HP and is the answer not in the manual?
Questions and answers