Audible Signals; Interrupting Cooking - Whirlpool MT9102SF Use And Care Manual

GETT IN G T O KN OW Y OUR M ICRO WAVE O VEN
10. COOK TIME. Touch this pad followed
by Number pads to enter cooking times.
See pages 20, 22, and 24 for more
information.
11. COOK POWER. Touch this pad, after
the cook time has been set, followed
by a Number pad to set the amount of
microwave energy released to cook the
food. The higher the number, the higher
the power or faster the "cooking speed."
See page 21 for more information.
12. CLOCK SET. Touch this pad followed
by Number pads to enter the correct
time of day. See page 17 for more
information.
13. Number Pads. Touch Number pads to
enter cooking times, cook powers,
weights, and quantities.
14. START/ENTER. Touch this pad to start
a function that you have set.
15. ADD MINUTE. Touch this pad to cook
for one minute at 100% cook power or
to add an extra minute to your cooking
cycle. See page 19 for more information.
16. OFF/CANCEL. Touch this pad to erase
an incorrect command, to cancel a
program during cooking, or to clear the
display after a function is completed.
This pad will not erase time of day.
NOTES:
• If you choose a preset automatic cook
function and change your mind, you must
press OFF/CANCEL before you choose
another preset automatic cook function.
• If you attempt to enter unacceptable
instructions, three tones will sound, and
"Err" will appear on the display. Touch
OFF/CANCEL and re-enter the instructions.
• Once you choose a function, an indica-
tor light ( ) will flash as a prompt for the
next action you need to perform.
• If you choose a function but do not press
another command pad within one minute,
the display returns to the time of day and
you have to start over.
16
• If you have entered all settings for a
function but do not touch the Start/Enter
pad in 5 seconds, the Start? indicator light
will flash.
• If you open the door while the oven is on
and then shut the door, the Start? indicator
light will flash.

Audible signals

Audible signals are available to guide you
when setting and using your oven:
• A programming tone will sound each
time you touch a pad.
• Five tones signal the end of a cooking
cycle and two tones will sound every
minute until you open the door or press
the Off/Cancel pad.
• Three tones will sound if you enter
incorrect instructions.

Interrupting cooking

You can stop the oven during a cycle by
opening the door. The oven stops heating
and the fan stops, but the light stays on.
To restart cooking, close the door and
TOUCH
If you do not want to continue cooking:
• Close the door and the light goes off.
OR
• TOUCH
NOTE: Before setting a function, touch
OFF/CANCEL to make sure no other
function is on.