Advertisement
Quick Links
Advertisement
Summary of Contents for Comcast 580A
- Page 1 580A Automatic Cable Tying Machine 580A www.comcast-sa.com...
-
Page 2: Table Of Contents
580A Contenido Regular Information ...........................3 Technical parameters: ........................5 Operation Instruction.........................6 Trouble Shooting..........................8 Maintenance............................9 After-sales Service ..........................9 Safety Instructions...........................10 Special Remarks..........................11 www.comcast-sa.com... -
Page 3: Regular Information
580A Regular Information Product name: Automatic cable tying machine Product model: 580A Product purpose: The machine is a hand-held, free climbing and cable quick attached tool, with internal placement of components such as controllers. The tool could automatically complete all steps of cable strapping and could be widely used in the field of communication engineering working at height, to replace traditional manual attached strapping cables. - Page 4 580A 1. High working efficiency In the same working environment, it's five times as much as traditional manual work and can work for 10 hours. It independent on the external circumstances and objective factors as well as suitable for all kinds of complex cable tying.
-
Page 5: Technical Parameters
580A Technical parameters: Product model: 580A Weight: 9 KGS Tying range: 5-58mm Iron wire diameter: 0.85mm Tying length/knot:700-750mm Knot/battery: 1500 knots Voltage: 12.8V Tying time: 0.8s Charging time: 1.5 h Battery capacity: 6600 mA/h .one battery can work more than 1500 times, about 3 km attached. -
Page 6: Operation Instruction
580A Operation Instruction. I. Take out the insulator of the battery and charge the unused lithium battery for 1.5hours before using the machine. While the charger green light is on and the red light is off, the battery has been fully charged. - Page 7 580A VIII. The construction personnel press the remote-control switch, and the attached machine will to the automatic spin, hinge tightly and cutting off. IX. Press the second operation after one operation, do not continue to operate many times, in case of the two-wire entangled together.
-
Page 8: Trouble Shooting
580A Trouble Shooting. Problem Causes Solution Turn on button doesn't 1.The battery is over-used Change battery or install work and machine cannot or damaged battery again after it is be opened 2.Failures of motor or fully charged. If still circuit board failed, send the machine 3.The battery is not insert... -
Page 9: Maintenance
580A Maintenance. 1. Please regularly inspect the machine and keep the jaw and other place clean. 2. When you have finished tying wires or when the machine will not be used for while, switch off the machine, remove the battery pack and put it into the original package. -
Page 10: Safety Instructions
580A Safety Instructions. 1. To avoid severe personal injury or property damage, read the manual carefully before using the machine. 2. Don’t allow children near the machine 3. Keep fingers and body parts away from the jaw and curl guide at all time 4. -
Page 11: Special Remarks
580A Special Remarks. 1. It is normal to find scratches on the arm of the machine, which are caused by machine testing. 2. When the wire is used up, pull out the rest wire along with the wire coil. Don’t cut the wire directly, or the machine will get stuck If the wire could not be pulled out, check if the wire cut blade was clamped, and revolve the jaw with diagonal pliers to pull out the wire.
Need help?
Do you have a question about the 580A and is the answer not in the manual?
Questions and answers