TechniSat Technipolar 1 Instruction Manual page 34

> Do not place the power cord or air conditioner near a heater, radiator, or
other heat source. There is a risk of electric shock or fire.
> The unit is equipped with a cable with a grounded conductor, which is
connected to an earthing pin or tab. The plug must be plugged into a
properly installed and grounded electrical outlet. Under no circumstances
should the earthing pin or tab be cut off or removed from the plug.
> The unit must be used or stored in such a way that it is protected from
moisture, such as condensed water, splashed water, and the like.
> Transport your air conditioner in a vertical position and place it on a stable,
flat surface while in use. If the unit is transported lying on its side, it should
stand upright for 6 hours and only then be connected to the power supply.
> Switch off the unit or the remote control using the switch on the control
panel. Do not start or stop operation by plugging in or unplugging the power
cord. There is a risk of causing electric shock.
> Do not press the buttons on the control panel with wet or damp hands.
> Do not use hazardous chemicals to clean the unit and keep them away from
the unit. To avoid damaging the surface, only clean the air conditioner with
a soft cloth. Do not use wax, thinners or strong cleaning agents. Do not use
the unit in the presence of flammable substances or vapours such as alcohol,
insecticides, petrol, and the like.
> If the air conditioner makes unusual noises or emits smoke or an unusual
smell, pull the plug out of the socket immediately.
> Do not clean the unit with water. Water can enter the unit and damage the
insulation, creating the risk of electric shock. If water has entered the unit,
immediately pull the power plug out and contact customer service.
> The unit should be lifted and installed by at least two people.
> Make sure that all accessories are removed from the packaging before use.
> When removing and installing the filter, do not touch the metal parts of the
air conditioner to avoid cuts. There is a risk of personal injury.
> Do not block the air inlet or outlet vents on the air conditioner. A reduced air
flow leads to poor performance and can damage the unit.
34