Whirlpool MH6700XW Use & Care Manual page 14

5. Touch a Number Pad for
the Cook Power you want.
The Display will show what you
touched. This example shows you
touched Number Pad 5 for 50% of
full power.
6. Touch START.
The AUTO SET and PROBE TEMP Indica-
tor Lights will stay on. The Display will
show "COOL" if the food is less than
90°F. As the food cooks, the Display
will show the internal temperature of
the food for every 5°F increase.
When the probe senses the tempera-
ture you selected, the oven shuts off.
"End" will show on the Display and 4
beeps will sound. (You can stop the
beeping by opening the door or by
touching CANCEL.) "End" will remain
on the Display and a reminder tone
will sound every 60 seconds (to
remind you that food is left in the
oven) until the door is opened or
CANCEL is touched. The Display will
then show the time of day.
NOTE: You can set Auto Set TEMP to follow COOK.
Auto Set TEMP can be programmed with the Temperature Probe out, but the oven will
pause between the last Cook cycle and "PROB" will show on the Display to remind
you to plug in the Temperature Probe.
Changing the Pre-Programmed Setting
You can change the pre-programmed temperature and Cook Power in Auto Set TEMP to
the temperature and power you most often use. To change the Auto Set TEMP setting, follow
these steps:
1.
Touch TEMP twice
2. Touch the Number Pads for the new desired temperature between 90°F and 200 'F
If HIGH Cook Power is desired, skip to Step 6.
3.
Touch COOK POWER
4. Touch the Number Pad for the desired Cook Power.
5. Touch START. The oven will cook to the new temperature at the Cook Power you
selected. After the cooking is complete, the oven will remember that temperature and
Cook Power for future use. NOTE: If the electric power goes off, the oven will go back
to the pre-programmed 465°F at HIGH Cook Power setting.