Removing/Replacing Microwave Oven - Whirlpool MH6140XF Use & Care Manual

R
EMOVING AND REPLACING THE MICROWAVE OVEN
wWARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or
other injury.
If you need to remove your Microwave Hood Combi-
nation for any reason, follow these simple steps:
To remove:
1.
Unplug microwave oven or disconnect power.
2.
Remove filters and vent grille.
B
C
A
located towards the center of the cabinet.
•
Remove the vent grille
grille aside.
3.
After removing all oven contents, including the
D
•
If filters are
installed, push in at the
tab and slide filter to the
outside edge to remove.
•
Remove the two
screws from the top
of the microwave oven
cabinet (the screws
located closest to the
front corners). Do not
remove the screws
. Set the screws and
turntable and support,
tape the door in the
closed position. Then
remove the two bolts
securing the
microwave oven to the
upper cabinet.
4.
While wearing gloves, grasp the microwave oven
E
F
5.
Grasp the microwave oven cabinet. Rotate the
G
INSTALLATION INSTRUCTIONS
supports and firmly
pull the microwave oven
forward and downward to
release the microwave
oven cabinet from the
mounting plate locking
pins .
microwave oven down-
ward. (Be careful that
door does not swing
open.) Lift off the support
tabs at the bottom of
the mounting plate. Set
the microwave oven
aside on a protected
surface.
continued on next page
7