Bluetooth car handsfree earpiece usb charger (4 pages)
Summary of Contents for anko 207C
Page 1
Instruction Manual For Battery Charger 207C Rated Input: AC 220V-240V Frequency: 50-60Hz Input Power: 40W Rated Output: DC 12V 2A Not for commercial or industrial use...
Page 2
Please read these instructions carefully before use. The 207C battery charger is designed to charge 12 volt lead acid batteries. This charger is simple to use and operate and an easy solution to charge your flat battery in your car, boat or motorcycle.
Page 3
Note: the output leads are fitted with coloured insulated clips for easy identification of polarity – RED for POSITIVE and BLACK for NEGATIVE Ensure the power point is switched OFF before connecting or disconnecting the charger to a battery. If possible remove the battery from the vehicle, if not, ensure that the battery leads are disconnected to protect the electronic systems within the vehicle.
Page 4
This situation can occur when the battery is in a deep discharged state (under 9volts). If all three LED lights remain illuminated after several hours when first connected, please consult an Auto Electrician to have your battery tested as there could be a fault with the battery.
Page 5
OTHER MEDICATION UNLESS INSTRUCTED BY A DOCTOR. IMPORTANT NOTES • The 207C is designed to charge 12 volt automotive lead acid batteries in the capacity range of between 15-80 amp hours. Most small car batteries are in this range •...
Page 6
authorized service facility. (2). Keep the handle dry, clean and free from oil and grease. (3). Ensure that the ventilation slots are kept clean and free from dust at all times. Blocked ventilation slots can cause overheating and damage to the motor. (4).
Page 7
For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation. MADE IN CHINA ® ANKO, HOME&CO. AND PERFORMER TRADEMARKS OF KMART AUSTRALIA LIMITED.
Need help?
Do you have a question about the 207C and is the answer not in the manual?
Questions and answers