Download Print this page

Philips BRP710 Manual page 2

Advertisement

1
Take the product out of the packing box.
Shrink
Wrap
Protective
Cover
Luminaire
Mounting
3 Core Cable
Bracket
Note: Remove Shrink Wrap and Protective
cover before installation.
Mount the luminaire with the Pole.
3
Horizontal Mounting
Note: Tightened the bolts
Vertical Mounting
with torque of 8Nm.
Pole Dia:
48
to 60mm
5
Below mentioned inclinations are possible.
0°,5°,10°,15°.
*
Note - Representation product images and actual product may vary based on
versions
Pass the wire through the pole and
2
mount the luminaire
4
For Vertical Mounting installation
Unscrew the Screw and remove the
pole Mounting Bracket and assemble
it as shown in Fig. B.
Fig. A
Fig. B
For accurate angle positioning, marks
6
are made over the clamping position
of the luminaire. Match the pole
mounting piece marking with luminaire
marking
0°-15°
Tilt the luminaire by rotating it and
To switch ON the luminaire Press the
Tilt the luminaire by rotating it and
Tilt the luminaire by rotating it and
5
5
7
5
open the 4 screws with srew-driver.
open the 4 screws with srew-driver.
open the 4 screws with srew-driver.
switch button shown in below figure.
Precaution:
1. This luminaire will not operate below 0 degree ambient.
2. Maximum installation height is 5m.
3. Before installation check the luminaire by pressing the switch
and make sure that it is glowing.
4. After three months of manufacturing it is necessary to check the
glowing of the luminaire, if it is not working then contact to
customer care.
5. After installation and during commissioning of luminaire, first
press the switch to switch it ON and then connect AC 230Vrms
input to the luminaire.
6. If two red and orange colour LED's start blinking then first remove
AC input connections and press the switch to switch off the
lumianire and wait for min two minutes. Subsequently follow
same commissioning sequence as per point no. 5
15°
7. The Light source of this luminaire is not replaceable; when the
10°
light source reaches its end of life the whole luminaire shall be
replaced.
Switch

Advertisement

loading

This manual is also suitable for:

501850005019280050199700