Advertisement
Names of parts
❶ Mute switch/battery tester
When the guitar is connected to a speaker or amp, turn on this button to mute When the guitar is connected to a
speaker or amp, turn on this button to mute flash one time in red if there is adequate battery power, and will light
in red if the battery power is too low. When the guitar is not connected to a speaker or amp, you can turn on this
button to test the batteries.
❷ Battery holder
Replacing the batteries
1. Press the tab on the battery case and pull out the battery holder.
2. Remove the old batteries from the battery holder and insert 2 new CR2032 (3 V) lithium coin batteries. Note the
battery direction indicated on the battery holder and insert the batteries with their + (positive) and – (negative)
terminals in the correct direction.
3. Insert the battery holder into the batter case until it clicks into place.
※ When replacing the batteries, always replace both batteries. Never mix old and new batteries.
※ If the guitar's sound becomes distorted, if the volume is too low, or if the battery tester LED lights in red, it is time
to replace the batteries.
※ Dispose of used batteries in accordance with local regulations.
1
Ibanez Custom Electronics (AHA1)
Ibanez T bar under saddle pickup
Endpin jack integrated preamp
Battery box
Advertisement
