Quick Start - Ebyte E108-GN01 User Manual

Chengdu Ebyte Electronic Technology Co., Ltd

2 Quick start

For testing E108-GN01-TB，if there is no board available, please refer to schematic of it in reference file.
1. After the GPS antenna is connected, connect the computer with a USB cable at the same time. There is a
USB port on the opposite side of the antenna of the board, and then press the switch button to turn on.
2. Note that when using an active antenna, the two RF_POWER pins need to be shorted with jumpers.
3. You can open the serial port assistant to view the data reported by the serial port, or you can use our naviTrack to
view it.
The baud rate is set to 9600 bps. Data will be reported after the serial port is closed. Common output formats are as
follows:
Copyright ©2012–2019，Chengdu Ebyte Electronic Technology Co., Ltd
E108-GN01 User Manual
3