Shark LED Light Instructions For Installation And Use

Table of Contents

Download this manual

Shark

LED Lights

LED Bars

Instructions for installation and use

USE OF THE PRODUCT

Dear customer, thank you for purchasing SHARK Led Lights / LED Bars. These lights are intended for

retrofitting to vehicles with a 12V electric system. Read instructions in this manual carefully before

Installation, and follow the guidelines. SHARK LED Lights and LED Ramps are water resistant, with IP

protection level indicated on your product packaging. The lights shall be mounted and used in

accordance with the regulations and this manual. Neither manufacturer nor seller shall be liable for

damages caused by improper installation, or using the light in contrary to these instructions. With

improper installation, improper interference with or modification of the lights you are taking risk of

damage to the lighting or machine, and loss of warranty. It is recommended to entrust assembly to a

specialized service workshop. This light is not approved for the road use.

2020

Table of Contents

Need help?

Do you have a question about the LED Light and is the answer not in the manual?

Page 1 Instructions for installation and use USE OF THE PRODUCT Dear customer, thank you for purchasing SHARK Led Lights / LED Bars. These lights are intended for retrofitting to vehicles with a 12V electric system. Read instructions in this manual carefully before installation, and follow the guidelines.
Page 2 4. Do not use damaged LED light or its power switch again; replace them immediately. 5. Do not use LED light/LED ramp or switch if it has been subjected to a heavy impact, fall, or is damaged in any other way. Consult a qualified technician in case of any damage.
Page 3 Electrical wiring WARNING: It is recommended to leave the installation to a professional service workshop. A. WIRING WITH THE ACCESSORIES SOCKET CONNECTOR (if your vehicle is equipped with this connector and you have the correct counterpart connector). B. WIRING WITH 15A FUSE...
Page 4 C. WIRING WITH 12V ACCESSORY SOCKET Remarks:  All wiring must be carried out in such a way as to be well insulated against moisture and humidity.  After mounting and wiring, aim the lights in the proper direction and tighten all mounting hardware. This product is designed and manufactured with high quality materials and components, which can be recycled and reused.

Led bar