Energizer 10343-CO-10 Assembly And Care Instructions

Assembly
Attaching the post to the ground stake
Remove inverted ground stake
stored inside the post.
Attach the post (C) to the ground stake (D)
by pushing the post (C) onto the top of the
ground stake (D).
Push the post-stake assembly into the ground.
CAUTION: The ground stake is sharp.
Be careful when handling to avoid injury.
Attaching the solar housing
Attach the solar top housing (A) on top of the glass lens (B) using a
clockwise twisting motion.
© 2019 Energizer. Energizer and certain graphic designs are trademarks of Energizer Brands, LLC and related subsidiaries and are used under license by Alpan Lighting Products, Inc.
All other brand names are trademarks of their respective owners. Neither Alpan Lighting Products, Inc. nor Energizer Brands, LLC is affiliated with the respective owners of their trademarks.
SOLAR PATHWAY LIGHTS
MODEL # : 10343-CO-10 (COPPER) 10343-BZ-10 (BRONZE)
10343-GM-10 (GUNMETAL) 10343-SS-10 (STAINLESS STEEL)
ASSEMBLY AND CARE INSTRUCTIONS
IMPORTANT: Retain for future reference. Read carefully.
A
Solar Top Housing x 10
B
Glass Lens x 10
C
Post x 10
D
Ground Stake x 10
10-PACK
10343-BK-10 (BLACK)
Choosing the Right Location
Your solar lights should be installed in an area that gets DIRECT SUNLIGHT. Your
solar lights will produce more hours of operation when installed in an area which is
free from cover, shade or shadowing.
NOTE: If the ground is hard and packed, moisten the ground with water
before inserting the stake to avoid breakage.
How Solar Lights Work
Solar lights have a solar cell that converts sunlight into electricity. This electricity is
used to recharge the built-in battery each day. Since the solar lights are powered
entirely by the sunlight they receive each day, operating time will vary by specific
location, daily weather conditions, and season.
Removing the battery tab
If light is packaged with the solar top hat (A) attached to the glass (B),
remove using a counter-clockwise turning motion. If the solar top housing
is separate, proceed below.
Remove the battery tab from the battery compartment on the solar top
housing (A).
A
Inserting the solar light assembly
Insert the solar light assembly on top of the post (C).
Made in China
1
1-800-7 1-1585 1
Made in China/Hecho en China/Fabriqué en Chine
Use Rechargeable Battery Only
Sólo Use Batería Recargable
Utilisez La Pile Rechargeable Seulement
Ni-MH A 1.2V 800mAh A
Manufacture Date : 11 / 2018
NOTE: Do not use a hammer.
If the ground is hard, use
water to soften.
IMPORTANT: Do not press down
on the solar panel on top of the
solar top housing (A). This can
damage the light.
CARE AND USE
INSTRUCTIONS
For assistance with assembly or
installation, parts and customer
service, please call
1-800-711-1585
Monday thru Friday
9:00 AM to 5:00 PM (PST)
Remove battery tab
Remove Tab Before Use
Enlever Avant d'utiliser
Quitar La Lengueta Antes De Usar
C