Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Lippert Components SolidStep 3.0 Lift Assist
- Page 1 SolidStep 3.0 Lift Assist OEM INSTALLATION MANUAL ®...
- Page 2 TABLE OF CONTENTS System Information Safety Information Resources Required Prior to Installation Installation Place Assembly Inside Doorframe Adjust Transport Lock Secure Hinge Plate Attach Strut Operation Adjust Leg Extensions System Information The SolidStep® 3.0 is a trailer entry step assembly that can be mounted to the side of any trailer, providing an ease of entry, regardless of level ground.
- Page 3 Resources Required • 1 to 2 Persons, depending on task • Cordless or Electric Drill or Screw Gun • Appropriate Drive Bits • Tape Measure • Backer Plate with Appropriate Fasteners • #10 - 1 " Self-Tapping Screws (laminate floor) or #10 - 1 "...
- Page 4 Do not attempt to lock the step in place, as the latching mechanism may need to be adjusted to the proper left-right orientation and tightened in position before using the transport lock. Attempting to engage the transport lock without proper adjustment may cause damage to the doorframe or step assembly.
- Page 5 Secure Hinge Plate After adjusting the transport lock and with the step assembly in the upright stored position, secure the 1/2" hinge plate (Fig. 4A) to the floor of the trailer using nine additional fasteners; either #10 - 1 self- 1/2"...
- Page 6 Attach Strut Remove the trim on the inside of the doorframe where the strut mounting bracket is to be installed. NOTE: Door trim removal is a requirement to prevent interference issues. The trim may be cut to length and installed so that it ends 28 "...
- Page 7 Operation Adjust Leg Extensions After extending the step assembly, the leg extensions (Fig. 9A) can be adjusted. The leg extensions are secured with spring loaded, self-latching levers (Fig. 9B). Adjustments can be made to the leg extensions in 1" increments (Fig. 9C) by moving the inner legs up or down for the optimal angle and to adjust for the ground surface angle.
- Page 8 The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the SolidStep 3.0 Lift Assist and is the answer not in the manual?
Questions and answers